To remove the rear deck speakers in a 2000 Chrysler LHS, start by carefully prying off the speaker grilles using a flathead screwdriver or trim tool. Once the grilles are removed, unscrew the speakers from the mounting brackets and disconnect the wiring harness. After detaching the speakers, you can replace or repair them as needed. Always ensure the car's battery is disconnected before starting the process to prevent any electrical issues.
Remove the covers to your 2000 Chevy Malibu rear speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install your new rear speakers.
Remove rear seat, them remove rear deck to get to the speakers.
Begin by removing the cover from your rear speakers. Remove the rear speaker retaining screws. Remove the wiring harness from the back of the speaker. The rear speakers will come out.
from the inside of trunk
Remove the rear door panel.
Impala HQ .com
Remove the rear speaker covers from your 2000 Buick Park Ave. Remove the rear speaker retaining screws. Remove the wiring harness. Reverse the process to install the new rear speakers.
You need to remove the rear seat to access the speakers and remove the covers.
There should be a grille covering the speaker. A Flathead screwdriver can pop it off. From there, unscrew the screws holding the speaker in place, and unhook the wires. The rear deck ones are a bit more tricky You have to remove the entire back seat as well as the cover on the rear deck. The 2 speakers are located underneath. they are 6x9s.
You have to remove the bottom rear seat cushion by pulling up and out at the same time, then remove rear seat back by removing 2 bolts that hold it to frame. Rear shelf can be removed to gain access to speakers.
Remove the cover from your 2001 Kia rear speakers. Remove the rear speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new rear speakers.
Pop the speaker grills off with a small screwdriver, then there is 4 screw holding speaker in place, as you lift the speakers out unplug the connector.