The first thing to do when replacing an AU Falcon steering wheel is to disconnect the battery as there is an air bag that contains a small explosive material that is potentially dangerous. Next, find the screws that hold the steering wheel cover, located on the sides of the steering wheel (under round plastic covers that can be removed with a small screw driver). Use a Torq #9 screwdriver to remove the two screws underneath these covers. Carefully lift out the steering wheel hub & airbag. Unplug the airbag. Use a Torq #9 screwdriver to remove the center steering wheel bolt. Use a steering wheel puller per factory specifications to remove the steering wheel.
To remove a pressure switch in the power steering Au Falcon the proper tools must be obtained to take the piece apart. The proper instructions must also be obtained.
Under the RHS of the steering wheel, next to the hood release
To replace the rear wheel bearing on a 1998 AU Falcon, first, lift the vehicle and remove the rear wheel. Next, detach the brake caliper and rotor to access the wheel hub. Remove the hub assembly by unbolting it from the axle, then press out the old bearing and press in the new one. Finally, reassemble the components in reverse order, ensuring everything is securely tightened and properly aligned.
get is reconditioned or new parts. there is no real temperary fix for any power steering component.
The XF falcon bullbar will fit a AU falcon with a little bit of fabrication.
Ford AU Falcon was created in 1998.
must CHECK HORN RELAY IN ENGINE COMPARTMENT SEEK A RELAY DIAGRAM BUT FOR MEMORY I BELIEVE IS THE NO. 4 RELAY. I CAN NO GIVE YOU AN ANSWER REGADING THE STEERING WHELL CONTROL.
You need an AU Falcon towbar.
no
Only the AU IRS version.
ford falcon au's take 5x7 speakers front and back
au falcon dosent have a distrutor cap they run 6 pin coil pack