answersLogoWhite

0

I'll make some assupmtions here:

It's not a 3500HD truck. The HDs have a full floating rear axle that can be removed without pulling the wheels. You just unbolt the outside cap and pull it out.

If it's a truck, it is a standard duty either 1500 or 2500. You're going to have to pull the diff cover and partially disassemble the locker to get at the ends of the axles. There's a C clip at the end of the axle that has to be pulled out in order to release it. You have to put a little inward pressure on the axle in order to allow the clip to be pulled off. A good service manual should have pictures to help you.

If it's a car, the issues are the same as above.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Can you put in a axle locker if the car has abs brakes?

yes


How do you remove the rear axle on 2001 Chev Camaro Z28SS?

I'd suggest attaching C4 or some other plastic explosive to both wheels and underneath the car and then blowing it off.


How do you remove a sticky mirror from locker?

You need warm water to remove a sticky mirror from the locker.


How do you correctly install axle locker sensor behind actuator plate on 2005 rubicon?

To correctly install the axle locker sensor behind the actuator plate on a 2005 Rubicon, first, ensure the vehicle is on a flat surface and safely elevated. Remove the actuator plate by unscrewing the bolts and gently pulling it off. Position the axle locker sensor in its designated slot, ensuring it aligns properly with the locking mechanism, then reattach the actuator plate, tightening the bolts securely. Finally, reconnect any electrical connectors and verify that the sensor is functioning correctly.


How do I remove the rear hub in my 1994 mustang 3.8?

That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing


How do you remove front axle from a Pontiac grand prix?

Remove the front tires, from your Pontiac Grand Prix. Remove the brakes and rotors. Unbolt the axle from the suspension. Remove the axle.


Diagram of front axle in chev Tahoe?

you can purchase a manual at any autostore, it's copywrited material..


Can you remove oil pan on 2004 Dakota with 5.9 v8?

Yes, if you remove the front axle first.Yes, if you remove the front axle first.


How do you change axle seal on 2006 Saturn Vue?

Remove the tire and wheel. Remove the axle end cap. Remove the axle seal with a seal puller. Reverse the process to install the new axle seal.


How do you remove rear axle F250 Ford?

how to remove rear axle from 1988 f250 ford


How do you remove cv axle Ford Aspire?

To remove the CV axle from a Ford Aspire, first, raise the vehicle and secure it on jack stands. Next, remove the wheel and brake components to access the axle. Disconnect the axle from the hub by removing the axle nut, then use a pry bar to pop the axle out of the hub assembly. Finally, remove the retaining bolts from the transmission side and gently pull the axle out of the transmission.


How do you remove axle from 96 dodge neon?

remove wheel, disconnect tie rod end, separate lower ball joint from control arm, remove axle nut, slide hub off axle, pull axle from transaxle housing