1. With all doors closed and the ignition switch in any
position except On or Start, buckle the driver's seat belt.
2. Turn the ignition switch to the ON position and wait
for the Seat Belt Warning Light to turn off.
3. Within 60 seconds of turning the ignition switch to the
ON position, unbuckle and then re-buckle the driver's
seat belt at least three times within 10 seconds, ending
with the seat belt buckled.
NOTE: Watch for the Seat Belt Warning Light to turn on
while unbuckling and off while re-buckling the seat belt.
It may be necessary to retract the seat belt.
4. Turn the ignition switch to the LOCK position. A
single chime will sound to signify that you have successfully
completed the programming.
1. With all doors closed and the ignition switch in any
position except On or Start, buckle the driver's seat belt.
2. Turn the ignition switch to the ON position and wait
for the Seat Belt Warning Light to turn off.
3. Within 60 seconds of turning the ignition switch to the
ON position, unbuckle and then re-buckle the driver's
seat belt at least three times within 10 seconds, ending
with the seat belt buckled.
NOTE: Watch for the Seat Belt Warning Light to turn on
while unbuckling and off while re-buckling the seat belt.
It may be necessary to retract the seat belt.
4. Turn the ignition switch to the LOCK position. A
single chime will sound to signify that you have successfully
completed the programming.
The fuse box on a 2007 Dodge Dakota is under the hood next to the battery.
Where is the pcv valve on 2007 dodge dakota 4.7 mag. Eng.and the egr valve also?
Get a clip, shhding.com
You can reset the check engine light on a 2007 Dodge Dakota by unhooking the battery. Leave it unhooked for 10 minutes before reconnecting it.
5 x 5.5
Rear wheel abs was standard equipment on a 2007 Dodge Dakota. Four wheel abs was optional. If you have wiring going to the front wheel bearings for sensors, it is four wheel abs.
No, the rims will not clear the calipers.
can youi show me how to pop off the panel to remove the radio in the 2007 dodge ram.
The Dakota has been made since the first model year in 1987 an continues to be produced by Chrysler Corp.
get a person who know how to do it
Remove your center console. and then you will be able to see the whole module
remove the door panels