first you pull off the the cowl panel and there will be a bolt under it and three on top of the fender. Then remove the front grill {there is four sctews on top of it}. There will be one or two bolts in front. then there is a bolt or two when you open the door you shoule be able to see them. then there is a bolt on the bottom of the fender at the back. Then remove the in fender bolts connecting it to the fender.
eBay!
Remove the lower panel from left fender .
Remove the rivet holding the wheel well fender. You can then pull the wheel well fender back enough to reach behind it and then you will be able to reach the bulb assembly.
If it is an 2.5L or 4.3L, itis under the hoodon the firewall, drivers side. If it is the 2.8L, it is under the hood on top of inner fender, drivers side.
passenger side right in front of the strut tower by the inner fender wall
To remove the driver's side fender on a 1992 Dodge Dakota, first, make sure the vehicle is parked on a level surface and disconnect the negative battery cable for safety. Next, remove any bolts securing the fender, typically located in the engine bay, along the top edge, and behind the wheel well. You may also need to remove the wheel and tire for easier access. Once all bolts and clips are removed, carefully pull the fender away from the body of the truck.
unscrew it might have to jack up car and remove tire to reach some bolts yea the 97 fender and the 95 are interchangeable 2 bolts at the core support, 2 under the rocker cover, one or 2 at the firewall under the wiper cowl. 1992-2011 fenders are all interchangeable furthermore the entire front end is interchangeable from 1992 to 2011 provided you change some key parts, but the fenders ALWAYS remain the same.
yes they will fit with no problem rubs the fender well in the front a little
How do you flush the raditor on a 1992 GMC Sonoma Pickup.
it is in the drivers side fender under the reserve tank just take off your wheel and remove the plastic fender cover and you will be able to see it
Open hood and disconnect the wire from the horn itself located under right front fender.
The water pump is located on the front of the engine down low. Right behind the front fender and next to the oil filter