0
One to repair an ignition switch on your Astro Van is buy a replacement steering column from a local salvage yard including the ignition key, and replace the whole steering column. RC Houston, TX
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Remove ignition cylinder?
key switch tumbler removal on 1998 astro
How to Remove a 1998 BMW z3 ignition switch?
Begin by removing the retaining ring at the top of your 1998 BMW ignition switch. The ignition switch will slide out. Remove the wiring harness.
How do you remove the ignition switch on your 98' Chevy lumina ltz car?
You will need to remove the retaining ring at the top of your 1998 Chevy Lumina ignition switch. Slide the ignition switch out. Remove the wiring harness.
How do you change ignition switch on 1998 Buick century Do you have to remove the steering wheel?
do I remove steering wheel to change out ignition
How do you remove ignition tumbler 1998 Ford Mustang?
How do you remove ignition tumbler 1998 ford Mustang?
How do you remove the ignition key switch on a 1998 Chevrolet truck?
Removing the ignition key switch from a 1998 Chevrolet truck is a relatively straightforward process. Before beginning it is important to make sure that the truck is off and the battery has been disconnected. To begin you will need to remove the steering wheel by first removing the center wheel nut with a 12" socket and wrench. You should then use a steering wheel puller to remove the wheel. Once the wheel is removed the ignition key switch will be visible in the center of the steering wheel. To remove the ignition key switch you will need to remove the retaining clip and then unscrew the bolts securing the switch in place. After the bolts have been removed the switch can be removed and replaced with the new one.
How do you remove the steering wheel from a 2000 Chevy Astro van?
How do you remove the steering wheel on a 1998 Chevy astro van
How do you remove the ignition switch on a 1998 VW Jetta?
start by removing the shroud around the column. remove the assembly that houses the ignition switch, there is a spring catch located in the lock and tumbler, you will have to drill a small hole in the side to push this spring and while pushing the spring down rotate the switch and pull out.
Is there a kill switch on a 1998 dodge neon sport?
No, there is no kill switch except for the ignition switch.
How do you get the ignition out of a 1998 astro van?
Don't try to do it yourself. Airbags tend to be a little touchy, and if you make a mistake it could injure you and be quite expensive for a new airbag. You need to pull the steering wheel. There are one or two screws under the turnsignal switch that holds the ignition switch in place. Pull the screw and the switch should come out easily.
How do you remove key switch Ford Contour?
how do I remove the key switch from a 1998 ford contour You have to remove the plastic trim around the steering column (behind the steering wheel). Put the key in the ignition cylinder and turn one click. There is a small hole on the side of the ignition cylinder, stick a small screwdriver into this hole and press hard. Pull out the ignition cylinder with the key.
Why won't 1998 Chevy astro will not start has fuel and spark?
ignition module failure or ecm failure.
