answersLogoWhite

0

Properly raise, support, and remove wheel from vehicle.

Loosen the nut that is on inner tie rod which is fastens to the outter tie rod.

Remove cotter pin from outter tie rod stud nut and loosen nut a few turns.

Use a small sledge hammer to strike steering knucle (wear safety glasses) where outter tie rod is inserted.

Repeat until tie rod becomes loose.

Do not strike tie rod but you can gently hit stud to see if it has become loose from steering knuckle.

While holding inner tie rod in place, count how many turns it takes to remove outter tie rod, then install new tie rod with an equal amount of turns (while holding inner in place).

Use new hardware that comes with the new tie rod, and use grease gun to grease it until you see tie rod boot slightly move.

Tighten nut that fastens outter tie rod in place to inner tie rod, then tighten outter tie rod stud to steering knuckle and install cotter pin (do not overtighten any nuts).

Install wheel and you should get an alignment.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Would rims from a 2000 Chevy Venture fit a 2003 Chevy Venture?

Yes


Show you a diagram of a water pump for Chevy venture van 2003?

please show me a diagram of a water pump on the engine of a Chevy venture 2003


Where is the radiator drain plug on a 2003 Chevy venture?

The drain plug on the 2003 Chevy Venture is located on the bottom edge of the radiator. It is on the side facing the engine.


How do you change radiator in 2003 Chevy venture van?

yes


What is tire pressure for 2003 Chevy Venture?

32 to 35 psi.


Tune up on a 2003 Chevy Venture?

it cost 320.00 at the garage that's what i paid for it on my 2003


Will the motor out of a 2003 Chevy Venture interchange with a 1998 Chevy Venture?

Yes, those GM 3400 motors are the same. The transmissions are different -- 4L60e versus a 4L65e


What kind of gas mileage does a 2003 Chevy Venture get?

Check fueleconomy.gov. In my 2004 Venture we get 19 city 25 highway.


Where is the fuel cut off switch in a 2003 Chevy venture van?

it does not have one.


How do you remove the headlight switch from a 2003 Chevy venture van?

To remove the headlight switch from a 2003 Chevy Venture van, first, disconnect the negative battery cable to ensure safety. Then, use a flathead screwdriver to gently pry off the decorative trim around the switch. Next, remove any screws securing the switch, disconnect the wiring harness from the back, and finally pull the switch out of the dashboard. Reinstall the new switch by reversing these steps.


Does a 2003 Chevy Venture come 4 cylinder?

the only engine that comes in the venture vans is the 3400 (3.4L) GM V6


How do you change signal light bulbs on the rear on a 2003 Chevy Venture?

use an L key to remove the screws and the rest is easy. i had this problem also until i saw a mechanic do it.