0
1.There is a tensioner for each belt that is the first step remove belts from s/c and alternater socket and ratchet with pipe for leverage. am not going to waste my time if no one is needing this.
2.remove all plastic covering from top of engine.
3.unbolt fuel rails,pull injectors out with fuel rail.
What else can I help you with?
What type of oil goes into the supercharger on a 1992 buick park avenue ultra?
It is a special blend oil called "Supercharger Oil" The GM dealers can get it however it will cost around $8-$10 for a 4 oz bottle. Thank you, From www.SuperchargersOnline.com
Is there a supercharger on a 1992 BMW 325i?
No.
How do you get around the windshield wash storage bottle when trying to take out the battery of a 1992 Buick Regal 4 door?
you have to remove it
What is the best replacement radiator for a 1992 Buick Century?
another 1992 buick century radiator
How do you replace fuel filter on 1992 buick park ave?
Remove hose clamps Remove mounting bracket Install new following the fuel flow arrows
How do you replace the front speakers on a 1992 Buick road master?
Front speakers are in the door. remove screws on the door panel, then remove the panel and you'll see the speaker
Where is the knock sensor on a 1992 Buick Regal 3800?
Where is the knock sensor located on a 1992 buick regal
Where is fuel pump located on a 1992 Buick Riviera?
Where my fuel pump located on my 1992 Buick riviera
How do you remove the hubcaps on a 1992 Buick roadmaster?
Slow insert a flathead screw driver in the slot provided and push, hubcap will pop out
How do i remove oil level sensor 1992 Buick Roadmaster?
It is not an oil level sensor it is an oil pressure sensor. It just unscrews.
How do you remove ignition switch on 1992 Buick Skylark?
The complete instructions are in Haynes manual #38025 (1420). You actually have to remove the steering wheel first. Amazon should have this cheap.
How do you remove the water pump on a 1992 Buick LeSabre?
To remove the water pump on a 1992 Buick LeSabre, start by disconnecting the negative battery cable and draining the coolant from the radiator. Next, remove the serpentine belt, then take off the alternator and any components blocking access to the water pump. Finally, unbolt the water pump from the engine block, carefully remove it, and clean the mounting surface before installing the new pump.
