0
What else can I help you with?
How do you remove an ignition lock on 1989 GMC Sierra?
== ==
Where is the ignition module located in a 1989 GMC 1500 Sierra 5.7L V8?
The ignition module on a 1989 5.7 liter is located in the distributor. Remove the cap, then the rotor, and you will be looking at the module. The module is held in place with two screws. Real simple. Good luck, David
Where do you locate the ignition module on a 1998 GMC Yukon with HO 350?
the module is in the distributor the module is in the distributor. you will have to remove the cap and rotor. it should be held on by 2 screws. good luck
Remove rotor on 2000 GMC Sierra 1 ton?
Remove 2 small torx screws
How do you replace the ignition module on a 1999 gmc suburban?
To replace the ignition module on a 1999 GMC Suburban, first disconnect the negative battery cable to ensure safety. Remove the distributor cap and rotor to access the ignition module, which is typically mounted on the side of the distributor. Disconnect the electrical connectors and unbolt the module from the distributor. Finally, install the new module, reassemble the distributor, and reconnect the battery.
Ignition timing for a 1989 4.3 liter GMC engine?
Look on the vehicle emissions control label it is there.
Your gmc envoy won't start and key is locked in ignition?
My 2002 GMC Envoy won't start,no lights come on when trying to jump start the battery. And my key won't remove from the ignition. What's should i do?
How do you change the ignition switch on a 2004 gmc 1500 sierra truck?
how to remove cover to replace ignition lock cylinder and what type of tools do i need
How can you test a ignition module for a 88 gmc pickup?
Remove it and bring it to a NAPA store. They will test it free.
How can I remove old ignition switch and replace with new one on 1989 GMC 1500 pick up?
you will need a steering wheel puller and a laock plate remover. it is almost impossible to do this without a lock plate remover
97 gmc 5.7 vortech 4x4 that has no spark. what could be the problem?
Could be the ignition coil, distributor, distributor cap & rotor or even spark plugs and wires.
Have a 1990 Chevy 305 have put new ignition module cap and rotor have power to cap but no spark?
I have 1994 GMC 1500 with 305 mother if you cut the wire that comes from your ignition to the coil can it stop you from having fire to your
