first u have to recover the sys and put a vacume behind it then u can remove the compressor with out any pressure in the sys and just start aking off bolts as you remove them reinstll them with the new compresor dont forget to put in new seals when u replace the comressor
How do you install a starter in a 1977 Chevrolet Caprice Classic with a 5.7 liter motor?
Attach the wiring harness to the and of your 1986 Chevrolet Caprice ignition switch. Slide the ignition switch into the ignition slot. Tighten the ignition switch with the retaining ring.
how do you install a aftermarket radio in 1986 caprice
No you can not but you can install heavy duty springs that will raise the front end 2 1/2 to 3 inches.
You will need to remove the tire and wheel from your 1992 Chevrolet Caprice Classic. Remove the brake shoe spring and caliper. The brake shoes will come off. Reverse the process to install the new brake shoes.
To remove the headlamp bulb on a 1991 Chevrolet Caprice simply twist the retainer counterclockwise, remove the bulb from the headlamp capsule and unplug the bulb from the wiring connector. To install the new bulb plug it into the wiring connector, insert the bulb into the headlamp capsule and twist the retainer clockwise and you're finished.
This requires special tools to remove and install the ac clutch and bearing. The air gap on the ac clutch must be done during install.
1996 caprice can you remove 4.3 engine and install a 5.7?
install a mechanical oil pressure guage. should be between 15 and 40 psi at idle and up to 50 at high RPM
unscrew it from the bottom
by law you shouldn't be allowed to purchase an A/C compressor without having the proper ticket, and if you had the proper ticket you would not be asking this question, but in any case there is already a spot for the ac compressor on the block on the right front half of the engine. a four bolt mount is already installed ready to accept the compressor.
Begin by compressing the strut spring with a spring compressor. Remove the strut retaining bolts. Reverse the process to install the new strut.