also referred to as the Vapor Canister Purge Valve and is in\on the charcoal evaporator canister.
its under the floor above the spare tire location, locate the charcoal canister on the front of the gas tank and trace the vent line to the vent valve.
It is bolted into the transmission valve body. You will have to remove the transmission pan to get to them.
Solenoid going bad remove and replace starter assembly.
This is a bit over simplified and definitely not for the faint of heart. Remove battery and battery well (watch out for battery temp sensor) Remove electrical connection to TCC Solenoid Raise Vehicle Remove transmission pan (catch fluid in a pan) Remove transmission filter Remove valve body Remove TCC Solenoid Reverse steps using new TCC Solenoid Good Luck
* Disconnect the negative battery cable * Remove the air intake duct and the air cleaner housing assembly from the engine compartment * Disconnect the battery cable and the solenoid terminal connection from the starter solenoid * Remove the starter motor mounting bolts and detach the starter from the engine
* Disconnect the negative battery cable * Remove the air intake duct and the air cleaner housing assembly from the engine compartment * Disconnect the battery cable and the solenoid terminal connection from the starter solenoid * Remove the starter motor mounting bolts and detach the starter from the engine
* Disconnect the negative battery cable * Remove the air intake duct and the air cleaner housing assembly from the engine compartment * Disconnect the battery cable and the solenoid terminal connection from the starter solenoid * Remove the starter motor mounting bolts and detach the starter from the engine * Installation is reverse of removal
THEY are up in the transmission and bolted to the valve body. Need to remove trans. Pan to service them. There is more then 1 shift solenoid.
how to replace a radiator in a 1996 buick regal
You'll have to take the dash loos and all the electrical wireing then remove the dash from the vehicle. From there you'll have a brace over the block holding the heater core in place. Remove the brace and screws from the top cover, slide the core out and replace in reverse steps.
The TCC solenoid is attached to the Valve Body inside the transmission. You will need to drain your tranmission and remove the pan to access it.
.disconect negative battey terminal 2.raise vehicle. place on jack stands for safety 3.from under vehicle remove the starter brace 4.remove the wire harness from brace on transaxle bellhousing 5.remove the two bolts holding the starter. 6.lower slightly to gain access to the wires on the starter solenoid. disconnect electrial connectors from solenoid terminals. 7.remove from engine
remove neg. battery cable disconnect both electrical wires to starter solenoid. remove 2 14mm bolts that secure starter to transmission and remove starter