You either need a camshaft bearing installer/remover. Or just take the block to your local machine shop..
The camshaft position sensor on a 4.3L engine is inside the distributor near the rear of the engine. Has the intake manifold gasket been replaced? Sometimes it is overlooked to plug the sensor back in after this repair has been done.
55 by 43 by 25
You are suppose to use Plastigage to figure out how much they need to be torqued but i torqued mine at 43 foot lbs and and would recommend 37-45 foot lbs. Some people say 37 foot lbs but i used a torque wrench and 43 just seem to be the right amount to remove the bolts. 43 ft lbs is what i used to install them. Do this at your own risk! The only proper way to do this is to buy the gage from Autozone and follow the instruction manual. My cars been running for 5 years since i did it.
43 kg
code 43 is electronic spark control open circuit.
Yes. The base engine componants are the same. The differences are the intake and fuel delivery.
For a 1994 Toyota 22-RE engine, the torque specifications for the rod bearing caps are typically around 43 ft-lbs (58 Nm). For the crankshaft main bearing caps, the torque specification is usually about 50 ft-lbs (68 Nm). It's important to follow the proper sequence and pattern when tightening to ensure even distribution of force. Always refer to the specific service manual for your vehicle for the most accurate details.
a code 43 is failed to reach peak circuit in dwell time
-ABS system codes for 1995-98 = code 43 rear right inlet solenoid valve.
The 43 vortex engine number 10227196 was produced in 2021. The designation "43" typically indicates the model, while the serial number helps to identify its production sequence. For more specific information or verification, it may be helpful to consult the manufacturer’s documentation or database.
ignition coil circuit failure
I believe most of them have a 43 hp Kubota diesel engine in them. However, I'm not sure if they all do.