To remove diesel injectors on a Ford Transit Connect, first, ensure the engine is cool and disconnect the battery. Then, remove the engine cover and any components obstructing access to the injectors, such as the intake manifold or fuel lines. Carefully detach the electrical connectors and fuel lines from each injector, and use a suitable tool to unbolt and extract the injectors from their seats. Be cautious to avoid damaging the injector seats or surrounding components during the process.
by taking it out
you remove injectors and take them to a shop that has the equipment and knowledge to overhaul them. this is a specialist area
Remove the bolt holding it in Place
If your Ford Transit Connect won't start after changing the diesel filter, it may be due to air trapped in the fuel system. Make sure to bleed the fuel system to remove any air. Additionally, ensure that the filter is installed correctly and that all connections are secure. Lastly, check for any fault codes that might indicate other underlying issues.
my bmw 320 cd se 2004 sounds like it is miss firing. I was told that 1 of my injectors is not working. would this be correct?
To remove the injectors from a Massey Ferguson 3-cylinder Perkins diesel engine, first, ensure the engine is cool and disconnect the battery. Next, carefully remove any components obstructing access to the injectors, such as the intake manifold or fuel lines. Use a suitable injector puller or a gentle prying method to avoid damaging the injectors, and then unscrew them from their mounting. Always consult the engine's service manual for specific instructions and torque specifications.
The same way you would on the drivers side....
Remove front driver seat . Disconect battery . Remove wheels . Take cluch rod off . Clutch falls out . Refit as removed
you need to crack loose the injectors and let the fuel pump push some fuel (and air) out around them then tighten them back up.
To remove the driver's door lock from a Ford Transit Connect, first, ensure the vehicle's battery is disconnected for safety. Remove the interior door panel by unscrewing any screws and carefully prying it off to access the lock mechanism. From inside the door, disconnect the lock linkage and any electrical connectors, then unscrew the lock assembly from the door. Finally, slide the lock out of the door.
In a 2011 Transit Connect, the fuse box is located under the dashboard on the driver's side. To access it, you need to remove a panel situated beneath the steering column. Additionally, there is another fuse box located in the engine compartment, near the battery, which can be accessed by lifting the hood.
injectors 6.6 Chevy silverado