answersLogoWhite

0

Only the hinge pins can be replaced without major bodywork as the hinges are welded to the doors and the frame.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Do all mk4 fiesta 1.3 have pas?

Not all mk4 fiesta 1.3 have pas.


Are what size the door speaker in a Ford Fiesta Mk4?

5 1/4 inch, or 13cm


Is t reg fiesta a mk4 or mk5?

mk4


How do you replace the nearside door mirror on a 1.3 2000 Ford Fiesta Finesse 5 door hatchback?

Fitting wing mirror to MK4 Fiestatuff luck


Where is the clutch cable on a mk4 Ford Fiesta?

It does not have one. The mk4 fiesa has a hydraulic clutch.


Will a mk5 fiesta engine fit a mk4 fiesta cheers?

Yes,the mk4 and 5 chassis' are identical and generally any fiesta front wheel drivetrain can be transplanted into any other fiesta engine bay up to mk6.


How can i fix my mk4 fiesta heater?

Whats wrong with it?


Will mk3 fiesta front seats fit a mk4?

No, the floor pans are completely different. The MK3.5 will fit the MK4.


Can you put the dials from a mk5 fiesta zetec s in a fiesta mk4 finesse?

did you ever figure out if you can do this as i want to do the same


What is the difference between a MK3 and a MK4 Ford Fiesta?

just about everything


Where is indicator relay on a Ford Fiesta mk4?

Under the actual indicator. There are 5 screws holding the steering column cover together, remove them (all underneath the column) then under the indicator you will see the relay switch (black box thingy) Why do I know? I have a fiesta mk4 and the relay has gone, resulting in no indicators at all.. not even on the dashboard.


How do you remove the rear door handle assembly on a Mk4 VW Golf?

To remove the rear door handle assembly on a Mk4 VW Golf, first, ensure the door is open and remove the inner door panel by unscrewing any fasteners and carefully prying it off. Next, disconnect the linkage and wiring connected to the handle. Once that’s done, remove the screws securing the handle to the door, and then gently pull the handle out from the outside. Finally, reverse the process to install a new handle if needed.