You should get one of those Chilton's or Haynes books for Skylark and Grand AM for these years. Amazon has some dirt cheap. Its not that hard. First take out all the obvious screws that you see. I think you have about 6 of them. After all the screws are removed the panel will be loose but it still wont come off. Theres a lock ring that goes around the handle that you roll the window down with. Its pretty tight and once it comes off its gonna be in pretty bad shape. Theres probably some special pliers that remove this. I didnt bother putting this back on or getting a new one The panel will remain installed fine without it so will the window roller.
To remove the driver's door panel on a 1991 Buick Skylark, start by carefully prying off the plastic trim around the door handle and window controls using a flathead screwdriver. Next, remove any screws that are securing the panel, typically located near the door handle and along the bottom edge. Once the screws are out, gently pull the panel away from the door, starting from the bottom and working your way up to disengage the clips. Be cautious not to damage the clips or wiring for the window controls as you detach the panel.
Chain Saw
I have to replace the drivers side door handle on a 2006 Buick Lucerne. How do I remove the panel to access the bolts on the handle. (Like most panels there isn't visible screws to remove the panel.
This answer is based off knowledge of my '95 skylark, take it with a grain of salt because it could be different. On mine it is located on the drivers side, on the lower left panel of the dash. It should have a plastic cover that simply pops open.
Try http://www.gmpartsdirect.com/
In order to replace the drivers side mirror on a Buick Rendezvous, you will need to remove the door panel. You will have to disconnect the electrical connector and you will be able to remove the mirror and place the new one on.
1985 Buick Skylark fuse location: Remove the plastic panel, roughly 4" x 4", located on the left side of the inside of your glove box. I don't know where any relay switches are located.
Ah, the fuse panel on a 1968 Buick Skylark is usually located under the dashboard on the driver's side. It's like a little treasure chest where you can find the fuses to keep your car running smoothly. Just take your time and explore gently, and you'll find it in no time.
On a 1995 Buick Skylark, the fuel pump is located inside the fuel tank. To access it, you typically need to remove the rear seat cushion and the access panel or drop the fuel tank itself. It is important to relieve the fuel system pressure before attempting to remove the fuel pump for safety reasons.
To remove the front door panel on a 1997 Buick Skylark, first, disconnect the negative battery terminal for safety. Start by removing any visible screws, usually located near the door handle and along the bottom edge of the panel. Next, gently pry off the panel using a trim tool, carefully releasing any clips that may be holding it in place. Once the panel is free, lift it up and away from the door to access the speakers for replacement.
how do you remove left rear door panel on a 2008 buick lucerne cxs.
look under the panel under the steering wheel . look for a silver bulb