To remove the engine cover on a first-generation 1986 Astro Van, start by disconnecting the battery for safety. Next, remove any screws or bolts securing the cover—these are typically located around the perimeter. Carefully lift the cover off, taking care not to damage any attached components or wiring. If necessary, consult the vehicle's manual for specific instructions related to your model.
Take it off
The 1997 Chevrolet Astro EGR valve is located on the top of the engine valve cover. The EGR valve can be access from under the hood. You will not need to remove any engine cover.
Yes it would be easer to get at it with the dog house removed.
You will have to unbolt and remove the engine access cover inside the passenger compartment. Then you can easily get to the air cleaner.
On top of the RH Side of the Engine. You will need to remove the engine cover from the inside of the van to get to it. Just trace the coil wire from the distributor.
You have to remove the Engine Cover inside the Van. Two Larger Screws fasten the Engine Cover to the Firewall, near top of each side. Two Bolts Clamp the cover to the floor. You also have to remove the glove box storage unit. Two small screws and two nuts.
you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points,
there are also two bolts under the hood that hold the interior engine cover on
I the rear of the engine under the "doghouse" or cover behind the glove compartment.
It should be at the bottom front of the engine by the timing cover.
were is engine cover wot does it do
you remove the dog house and it will be on the left valve cover