0
What else can I help you with?
Is your mk6 transit have a obd2 connection and where is it?
Yes the MK6 Transit is OBD2 and the port is jus down below the steering wheel
Where is the oil cooler on mk6 transit?
On the Mk6 Transit, the oil cooler is typically located at the front of the engine, near the radiator. It is integrated into the engine block or mounted on the oil filter housing, depending on the specific engine variant. To access it, you may need to remove some components, such as the undertray or other engine covers. Always refer to a service manual for precise locations and procedures.
How rear fog lights does a mk6 transit have?
2
What size speakers are in Ford Transit Mk6 doors?
5x8
Where is the battery on transit mk6?
The battery is under the driver's seat
Where the battery on y reg ford transit?
On a Transit mk5 under the bonnet, on a Transit mk6 under the drivers seat
Where is the fog light switch on the dash of mk6 transit van?
pull out light switch
How big is a mk6 transit fuel tank?
80 litres or at todays money £100.24 to fill up
How do i remove the air filter on a fiesta mk6?
To remove the air filter on the Fiesta MK6, first remove the bolts on the top of the air filter box. Then, pull upward to remove the rubber gasket around the box. Remove the screws at the rear of the box. Remove the filter and replace it.?æ
Will a transit mk7 side loading door fit on a mk6?
A Transit MK7 side loading door is not a direct fit for a MK6 due to differences in design and dimensions between the two models. The hinges, mounting points, and overall door size may vary, making it necessary to modify either the door or the van to achieve a proper fit. It's advisable to use doors specifically designed for the MK6 to ensure compatibility and function.
Where is Mass air flow sensor on ford transit 2004 MK6 Compared to other transit vans but mine have none near air filter box?
behind passenger side headlight
How do you fit a wing on a mk6 transit?
Fitting a wing on a MK6 Transit involves several steps. First, you'll need to remove any existing damaged wing by unscrewing the bolts and clips that secure it to the body. Once the old wing is off, align the new wing with the mounting points and secure it using the appropriate bolts. Finally, ensure a proper seal with the body to prevent water ingress and check that everything is securely fastened before finishing up.
