take out screws
Should be secured by bolts in each corner of seat
remove the 4 nuts, one on each leg of the seat and unplug any wiring harnesses under the seat and pull out the seat.
If its a 96 you need to unbolt the center seat, Then there should be four bolts on the floor.
Just unbolt the seat from the floor and pull it out.
Underneath the pasenger seat. Unclip the cover, remove cover, and unscrew the wingbolt holding the jack.
There is a box under the center front seat that needs to be replaced, it was about $120 at Dodge dealer. You may have to remove entire front seat to do this, I did. I forget exactly what it was called....seat belt control module or something close to that.
Remove air filter assembly,undo both red and black cables on battery,remove front right wheel(if facing front from drivers seat-)take off cover insidde wheel well,slide battery out.
The battery is under the passenger front seat. Put the seat in the full forward position and remove the cover over the battery. You can than undo the cables and hold down bolt. the battery will now lift out.
Yes
The battery is behind the passenger seat. To get to it you must remove the floor mat on front of the second row seats; then remove the plastic cover covering the tracks of the right side middle row seat. This will then expose a carpeted cover held down by a torx head screw. Remove the screw and cover and the battery will be exposed.
Move the seat all the way forward, remove the 2 bolts on back of the rails, remove the side trim cover, remove the seat belt retaining bolt, tilt seat, disconnect wiring, remove seat. (See Haynes Repair Manual # 24047).....
4 bolts on each seat on the legs that bolt to the floor, take off and unhook any wiring to the seat that is under it and pull the seat out.