to get to the speaker you gotta remove the whole door panel. theres a bunch of scews along thr bottom and the side i think then you just gotta pull off the door panel. be careful cuz the door lever gets caught up an theres plastic clips on the back of the panel so try not to break them. once you get the door panel off the speaker is right there in front of you
5x8 rear 5 1/2 front
6.5 front - 6x8 rear
most 1992 Eddie Bauer bronco's are 3.55 in the rear and 3.54 in the front. that's what mine is with a 351w (5.8).
5x7 in the rear 6inch in the front
The 1990 Chevy Corvette front drivers side speaker cover will need to be removed. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
To remove a magnet in a speaker, first detach the grill in the front of the speaker, second unscrew the speaker after that remove the speaker from the cabinet and cut the speaker cone. Lastly, gently discard the magnet from the speaker cone.
The speaker covers are held in with a screw, remove it and tilt it out away from where the screw was. then remove the screws holding the speaker in and remove the speaker.
i have the same vehicle. iam in the process of restoring and not 30 minutes ago i asked myself the same question, the front 2 speakers on driver and passenger side doors are 5x5 and the rear is 5x8
The 1992 Chevy Corvette front speaker covers are held in place with two retaining screws. Remove the retaining screws and the speaker covers will come off.
1.Remove the front door trim panel.Remove the speaker retaining bolts.Disconnect the electrical connector and remove the speaker from vehicle. Installation is the reverse.
Remove the speaker covers, by loosening the retaining screws. Remove the speaker retaining screws. Remove the wiring harness. The speakers will come out.
You have to remove the whole dashboard and then the speaker should be exposed, then just remove it.