It is very easy. On the sides of the box you will see a small white plastic block with about a 1/2 inch diameter cylinder protuding from the side of the plastic block. The cylinder snaps into a hole in the the sheet metal fixed structural side panels. With the box open take a wide flat blade screwdriver and insert the tip between the plastic block and the metal side panel and lightly pry the plastic block until the cylinder is clear of the hole. You can then pull the right side of the glove box towards you and the box will come out of the dash. To reinstall it just push the box into place until the plastic block/cylinders engage the holes in the metal side panels.
take out your glove box an its right there
behind glove box. taker out glove box and you should see the controler on the right towards front of car
I am having trouble getting glove box out of 98 F150. I need a more detailed explanation of which screws need to be removed and their location.
It is in the glove box.
Remove the Engine Dog house from inside the vehicle. You will have to take off the glove box console first.
Inside the glove box
it is in the glove box--you have to undo the strap on the bottom part of the box first
sledge hammer! ftw
Remove Glove Box & Access Panel. Disconnect Blower Motor Electrical Plug & Aspirator Hose. Remove screws & Motor. Install in reverse order.....
i know its to do with a wire on the bcm, which is under the glove box, but i cant the right info online.. if its the same as 98 then you just gotta ground the blue wire on the center plug
The 1998 Chevrolet Malibu automatic window fuse is located in the fuse box. The fuse box is in the engine compartment. Replace the automatic window fuse.
In fuse box behind Glove compartment