On the bottom edge of the switch's plastic trim there is a small slot in the center. Insert a flat-bladed screwdriver and gently pry upward and outward. When the switch begins to come out, pry around the edge until it comes free. The switch is held in place with three small spring clips.
Turn the headlight switch on and pull it towards you.
on the dash
Where is the headlight relay switch on a 2001 Neon located?
How do you remove the headlight assembly on a 2001 camaro?"
how do i change out a power steering switch on a 2001 mercury sable with a 3.0 engine?
how do you remove the headlight assembly on a 2001 ford f-250
To change the headlight switch on a 2001 Subaru Legacy, start by disconnecting the negative battery terminal to ensure safety. Remove the steering column covers by unscrewing the screws, then gently detach them. Next, unplug the wiring harness connected to the old headlight switch and remove any screws or clips holding it in place. Install the new switch by reversing these steps, making sure everything is securely reconnected before testing.
location for fuse, and relay switch on a Mercury Sable
To change the headlight switch on a 2001 Audi TT, first, disconnect the negative battery terminal to ensure safety. Then, use a flathead screwdriver to gently pry off the trim panel surrounding the switch. Once exposed, remove the screws securing the headlight switch, disconnect the wiring harness, and replace the old switch with the new one. Finally, reassemble everything by reversing the steps and reconnect the battery.
Open the 2001 Subaru engine compartment hood. Remove the wiring harness from the back of the headlight. Remove the headlight assembly bolts. The headlight will come out. Reverse the process to install the new headlight.
On top of the steering wheel column
To replace the headlight control switch on a 2001 Mercedes CLK, first disconnect the battery to ensure safety. Remove the trim panel surrounding the switch by carefully prying it off, then unscrew the switch from its housing. Disconnect the wiring harness from the back of the switch and replace it with the new one. Finally, reassemble the trim panel and reconnect the battery to complete the installation.