answersLogoWhite

0

take the bezel nut off the outside of the ignition switch and then put your key in the ignition and get a paper clip and put it through the small hole in the part where the key fits and then push in on the paper clip and turn the key counter clockwise and pull the key and lock out.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you remove a ignition switch without a key from a 1964 ford falcon?

To remove the ignition switch from a 1964 Ford Falcon without a key, first disconnect the battery to ensure safety. Next, locate the ignition switch, typically found on the steering column. You may need to remove the steering column cover to access it. Use a screwdriver to carefully push or turn the locking mechanism or any retaining screws to detach the switch from the column, allowing you to remove it.


How do you remove the ignition lock cylinder on a 1964 Chevy puck up truck?

Turn it, then pull up and out.


How do you replace ignition switch on a 1964 mustang?

ignition is spring loaded.unscrew dash and push in ignition and turn it comes right out.


How do you wire a 1964 nova ignition switch?

To wire a 1964 Nova ignition switch, first disconnect the battery to ensure safety. Connect the battery power wire (usually a thick red wire) to the "B" terminal on the switch. Then, connect the "I" terminal to the ignition coil, and the "S" terminal to the starter solenoid. Finally, ensure all connections are secure and reconnect the battery to test the ignition.


How do wire a 64 nova ignition switch?

To wire a 1964 Chevy Nova ignition switch, start by connecting the battery power (usually a red wire) to the "BATT" terminal on the ignition switch. Next, connect the "IGN" terminal to the ignition coil for power when the key is turned on. The "ACC" terminal can be used for accessories like the radio, while the "ST" terminal connects to the starter solenoid for cranking the engine. Ensure all connections are secure and insulated to prevent shorts.


How do you wire 1964 VW Bug ignition switch?

The 1964 VW Beetle ignition switch only has three wires. Connect the red wire to the positive post. Connect the black wire to the negative posts. Connect the white wire to the auxiliary post.


How do you replace the ignition switch in a 1964 Ford Falcon?

on a 1963 Falcon..first remove the key insert by turning key allthe way to the left,. Then place a paper clip(straightend) into the hole in insert.Press in to release the spring while turning key farther to the left and remove insert..now the ignition swithch can be removed by pressing in from rear of dash and turn switch counter clockwise while holding switch retainer in from front..


How do you remove neutral safety switch from 1964 thunderbird?

To remove the neutral safety switch from a 1964 Thunderbird, first disconnect the negative battery cable to ensure safety. Then, locate the neutral safety switch, which is typically mounted on the transmission. Remove the electrical connectors and any mounting screws or bolts securing the switch in place. Finally, carefully slide the switch off the transmission and replace it if necessary.


What is the ignition timing setting on 1964 Chevy 283 2 bbl?

timing on my 283 4-barrel is 8 degrees btc.


How do you remove power window switch 1964 thunderbird?

To remove the power window switch from a 1964 Thunderbird, first, ensure the vehicle is off and disconnect the battery for safety. Carefully pry off the switch panel using a flat tool, taking care not to damage the surrounding trim. Once the panel is free, you can access the switch; disconnect the wiring harness from the back and unfasten any screws holding the switch in place. Finally, remove the switch from the panel.


Replace 1964 Thunderbird headlight switch?

Pull out type? There is a silver button on the side of the switch (behind dash) Push button and pull switch all the way out Then remove bezel and remove switch from behind dash Ford suggests replacing plug also


Should I keep the ignition switch on lock or off on a 1964 Impala to keep the battery from draining?

Yes. Otherwise you will drain the battery through the ignition points, burning them out prematurely or even welding them together.