To remove the inner fender well on a Ford Focus, first, ensure the vehicle is parked on a level surface and the ignition is off. Locate and remove the screws or clips securing the inner fender well, which are typically found along the top edge and front side. You may need to remove the wheel for better access. Once all fasteners are removed, gently pull the inner fender well away from the body to detach it completely.
front pass. side inner fender well, remove inner fender . You will then see the dryer . there is a black cap , remove , this is where the charge line goes
You don't remove the fender; the battery is behind the inner fender well behind the rear driver's-side tire.
Remove left front wheel, remove inner fender well, remove battery.
Remove the driver's side rear wheel; remove the inner fender well behind the wheel.
it's in the right fender well. remove inner fender and you'll see it.
the low side service port is behind the passanger side inner fender well most people will pull the wheel off then the inner fender but i have found it easier just to lay on the ground and reach in behind the fender there is a larger black cap that you have to remove to access the service port
the proper way is to remove the pass side inner fender well. then replace the motor. through the years many have just opted to cut a hole in the inner fender to access the blower motor. then cover the hole with a slightly larger piece of sheet metal and screw it inside the inner fender well to cover the hole.
To remove the right front inner fender on a 2000 Ford Excursion, first, ensure the vehicle is safely lifted and secured. Remove any screws or bolts securing the inner fender to the body, typically found along the edges and at the wheel well. You may also need to detach any clips or fasteners. Finally, gently pull the inner fender away from the vehicle, taking care not to damage any attached components.
Inner fender
Remove the left front (driver's side) front tire. Looking inside the fender well itself locate the screws and plugs that hold the plastic wheelwell to the metal fender. Remove them and pull the plastic fender well away from the back of the well. Underneath you will see the A/C ports.
It is necessary to either remove the passenger side fender or inner wheel well to access the heater fan in a 68 camaro.
It is on the back wall of the left front fender well - remove the tire and wheel - you must remove the wheel well liner to get at it.