Check the front end components for the cause
On a 1991 Chevrolet Caprice Classic, the power steering fluid reservoir is typically located near the front of the engine bay, often on the driver's side. It is usually a translucent plastic container with a cap labeled for power steering fluid. To check the fluid level, simply remove the cap and look for a dipstick or markings on the side of the reservoir. Always ensure the vehicle is off and the engine is cool before checking the fluid.
You have to remove the fuel tank to access the fuel pump.
You will need to remove the tire and wheel from your 1992 Chevrolet Caprice Classic. Remove the brake shoe spring and caliper. The brake shoes will come off. Reverse the process to install the new brake shoes.
The 1982 Chevrolet Caprice fender is held in place with eight retaining bolts. Remove the retaining bolts and the fender will come off.
In most cases you will need to replace the turn signal switch on the steering wheel for your 1983 Chevy Caprice Classic rather than fixing it. To replace it, remove the horn pad and then use a steering wheel puller and compressor to remove the steering column. You will then remove the signal along with the wiring harness and bus fuses. Replace the signal and wiring and then replace the steering column itself.
The turn signal relay on a 1988 Chevrolet Caprice Classic Brougham is typically located under the dashboard, near the steering column. You may find it mounted on the fuse panel or in the vicinity of the ignition switch. To access it, you might need to remove some panels or the lower dash cover. Always consult a repair manual for the exact location and procedure for your specific vehicle.
Remove the bolts but be prepared for alot of transmission fluid pouring out. You will need a large drain pan.
1996 caprice can you remove 4.3 engine and install a 5.7?
remove the lower shroud on the steering column, and then the 2 bolts that hold the column in place, it should be accessable then.
Disconnect the battery, locate the starter.. remove the mounting bolts, bring the starter down to where you can reach all of the wires going to the solenoid, and disconnect those.
with tools
How to change a heater cord for a 93 chevolete caprice