u take a pair of needle nose pliers and at the front of the knob near the bottom there is a pin that loks almost like a staple just pull it out and it will come off
Pull the knob out. There is a small slot in the side of the knob. Put a small flat blade screwdriver in the slot and pull the knob out. The screwdriver will release a clip and the knob will come off.
ya
Yes
Yes
Yes
The V6 in the 1997 Camaro was the 3.8, not the 3.4
caprice was not built in 97..
To remove the column shifter knob from a 1997 Toyota Avalon, start by locating the small set screw on the side of the knob, which typically requires a Phillips screwdriver or an Allen wrench to loosen. Once the screw is loosened, pull the knob straight off the shifter shaft. If it feels stuck, gently wiggle it while pulling upwards. After removal, ensure the set screw is properly tightened when reinstalling the knob.
200hp V6
3.23's
285 HP.
I would think so since they're the same engine, only with some minor modifications