Some of these are harder than others. Some you need to jack up the motor to remove the starter from below. Some you also have to loosen the trans from the body to jack the engine high enough to fit the starter through.
Follow the positive battery cable from the battery, it will lead you right to the starter.
Follow the positive battery cable from the battery, it will lead you to the starter.
how to remove the starter from a 92 s-10 4x2 with a 2.8 engine
On a 1996 Chevy S10 pickup truck, the starter is located on the passenger side of the engine, near the transmission. It is mounted to the bell housing, typically towards the lower part of the engine. To access it, you may need to lift the vehicle and remove any obstacles, such as the exhaust or heat shield, depending on your specific model and configuration.
To change the starter on a 1998 s10, the motor mount will have to be removed. Support the motor on a jack with a board on the top of it, and remove the mount to get to the starter.
Inside the headlight switch.
disconnect battery. remove cables at the starter. remove starter mount bolts. remove starter. replace starter. reinstall bolts. reinstall wires. reinstall battery cable.
Remove the two bolts holding the starter to the engine then you should be able to drop the starter down enough to take the wires off and remove the starter.
Remove one battery post connection. Remove wires from starter and be sure you know where they go back. Remove large bolts from starter and put the new one back in.
you have to remove the crossmember to do this.
remove passenger front tire then fold back the water guard then you will access to the starter
yes