more information needed
is it in the window or the design in the spoiler
Remove the wing nuts from inside the trunk, the assembly will pop out.
The brake light assembly can be access through the cargo compartment. Remove the cover to the brake light assembly. Take hold of the brake light connector, push in and turn at the same time. The brake light will come out. Reverse the process to install the new brake light.
To replace the brake light on a Citroen C1, first, open the rear hatch and locate the brake light assembly. Remove the screws or clips securing the assembly and carefully pull it out. Disconnect the electrical connector and twist the old bulb counterclockwise to remove it. Insert the new bulb, reconnect the electrical connector, and reassemble the brake light assembly.
Open the trunk, locate and remove the defective bulb from the socket assembly in the tail light assembly. Replace the bulb with a new one, and lock into socket. Close trunk.
The center brake light replacement will require replacing the entire brake light assembly. Remove the wiring harness. Remove the center brake light retaining screws. Reverse the process to install the new center brake light.
Remove the two screws in the lens. You can remove the entire assembly once you do this.
To change the brake light on a 2006 Acura, first, open the trunk and locate the tail light assembly. Remove the screws or clips securing the assembly, then gently pull the assembly out from the vehicle. Disconnect the electrical connector and twist the brake light bulb counterclockwise to remove it. Replace it with a new bulb, reconnect everything, and reattach the assembly to finish the job.
To replace the brake light bulb on a Toyota Highlander, first, open the rear hatch and locate the brake light assembly. Remove the screws or clips securing the assembly, then gently pull it out. Disconnect the wiring harness and remove the old bulb by twisting it counterclockwise. Insert the new bulb, reconnect the harness, and reassemble the brake light assembly.
Not possible. You have to remove the whole light assembly.
Remove the wiring harness from the high mount brake light. Remove the back cover of the brake light assembly. Take hold of the brake light connector, push in and turn at the same time. Reverse the process to install the new brake light.
To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.
You must remove the entire light assembly as follows: Lower the tail gate and remove the two small screws that screw into the side of the assembly. Next remove the two screws on the outside of the assembly that are accessible through long holes on the outside of the assembly. Pull the assembly back to expose the rear where the lights are located.