0
To remove the AC compressor from a 1997 Oldsmobile Aurora, first, ensure the vehicle is off and disconnected from the battery. Next, recover the refrigerant from the AC system using appropriate equipment. Once the refrigerant is removed, disconnect the AC lines from the compressor, unbolt the compressor from its mounting brackets, and carefully lift it out of the engine bay. Finally, replace any seals or O-rings before installing a new compressor if necessary.
What else can I help you with?
How do you install a water pump in a 1997 Oldsmobile aurora?
remove and replace water pump in 1997 Oldsmobile aurora
How do you replace the fuel injectors on a 1997 Oldsmobile aurora?
where are the fuel injectors in a 1997 oldsmobile aurora
Can you bypass the ac compressor on a 1997 Oldsmobile aurora?
Yes you can, use a duralast belt # 745K6 from autozone, it will run you about $28
Are there any differences between a 1996 and 1997 Oldsmobile aurora?
Are there any major differances between a 1996 and 1997 Oldsmobile Aurora
Where is the Relay located for the power windows in a 1997 Oldsmobile Aurora?
Most of the relays for the 1997 Oldsmobile Aurora are under the back seat on the drivers side.
How do you change a turbine speed sensor in a 1996 Oldsmobile Aurora?
Where is the speed sensor located on a 1997 Oldsmobile Aurora
What type of refrigerant does a 1997 Oldsmobile Aurora use?
R-134
Where can you download free pdf owners manual for 1997 Oldsmobile aurora?
The Owner's Manual and Operating Instruction for the 1997 Oldsmobile Aurora is offered on Manual Owl as a PDF. The website provides product manuals free.
How many spark plugs are on a 1997 Oldsmobile Aurora?
1 in each cylinder...........
Where do you locate the flasher fuse for a 1997 Oldsmobile aurora?
The 1997 Oldsmobile Aurora flasher fuse can be found in the fuse box. The fuse box is in the engine compartment. The location of the fuse will be listed on the inside cover of the fuse box.
Where is the AC low pressure recharge port on a 1997 Oldsmobile Aurora?
The AC low pressure recharge port on a 1997 Oldsmobile Aurora is located on the larger diameter aluminum line that runs from the compressor to the evaporator. You can find it near the front of the engine compartment, typically close to the driver’s side. It is important to ensure you are using the correct port for recharging the system to avoid any potential damage.
How do you remove engine out of a 1997 Oldsmobile aurora?
To remove the engine from a 1997 Oldsmobile Aurora, first disconnect the battery and drain the engine coolant and oil. Then, remove the air intake assembly, electrical connections, and hoses attached to the engine, including the exhaust manifolds. Next, support the engine with a hoist, detach the engine mounts, and carefully lift the engine out of the engine bay. Ensure you have a clear workspace and follow safety precautions throughout the process.
