Push very hard at the center of each back seat (left and right seat) towards the back of the car. Then, while pushing back, lift up. It will pop out of its catch.
Remove the decorative cover from your Cadillac Eldorado radio. Remove the radio retaining screws. The radio will slide out. Remove the wiring harness and the antenna cable from the back of the radio.
it should
under the intake plenum for the fuel injection. Not an easy job to do for the back yard mechanic.
On a 2000 Cadillac Eldorado, the temperature sending unit is located on the engine block, typically near the thermostat housing. It can usually be found on the driver's side, towards the back of the engine. To access it, you may need to remove some components or use a socket or wrench to unscrew it. Always ensure the engine is cool before attempting any work on the cooling system.
To remove the back seat in a Cadillac Eldorado, first, locate and remove any retaining screws or bolts, typically found at the base of the seat or behind the seat cushion. Then, gently pull the seat cushion upward to detach it from the clips or hooks holding it in place. For the backrest, you may need to unclip or unscrew it from the floor or back of the vehicle before lifting it out. Always refer to the vehicle's service manual for specific instructions and safety guidelines.
To remove the rear seat in a 1989 Cadillac Eldorado, first, locate and remove any bolts or screws securing the seat bottom to the floor. Once unfastened, lift the front of the seat bottom and pull it forward to disengage it from the hooks at the back. After removing the bottom, you can access the rear seat back, which may require unbolting or unclipping from the vehicle's frame. Carefully detach it to complete the removal process.
To remove the instrument cluster from a 1988 Cadillac Eldorado, first, disconnect the negative battery cable to prevent electrical shorts. Next, remove the screws securing the trim panel around the cluster and gently detach it. Then, unscrew the cluster itself and carefully pull it out, disconnecting the wiring harnesses from the back. Be cautious not to damage any connectors or the dashboard during the process.
It is normally on the lower right back of the engine.
back of right head
You get tools and you take it out or if you dont know how to take them out go to an engineer
16.7 feet or 200.9inchs
Where is the switch located for the back up lights on a 2000 cadillac daville