To remove the center console on a 2000 Oldsmobile Intrigue, start by disconnecting the negative battery cable for safety. Next, remove any screws or fasteners securing the console, which are typically located in the armrest compartment and around the base. Carefully pry up the center console, starting from the rear and working your way forward, ensuring to disconnect any wiring harnesses for components like the power outlet or shift indicator. Once all connections are free, lift the console out of the vehicle.
Remove (or have a professional remove) the center console. The cup holder may or may not be repairable.
Just remove the console and you can get to it.
To remove the center console on a 2000 Oldsmobile Alero, start by disconnecting the negative battery terminal for safety. Then, use a flathead screwdriver to gently pry off the trim pieces surrounding the console. Remove any screws or bolts securing the console in place, typically located at the front and rear. Finally, carefully lift the console upwards and out of the vehicle, ensuring to disconnect any wiring harnesses if applicable.
1st one is on the exhaust manifold by the last 3 cylinders facing the interior and the 2nd is almost directly under the center console shifter on top of the U-bend on the exhaust of course your might have to remove the pipe
lift up the center plate on the console were your gear select is after you remove your shift lever and all the lever pieces and there you can remove the top of the console and the bottom has 4 bolts 10mm remove those and you shift your car all the way down to first or low gear and lift it up un plug the harness and there you go
Take it out with your muscle.
Remove the lower radiator hose.
how do you remove the center console on a 2005 toyota camry
how do you remove a center console on a 2001 toyota corolla
To replace the bulbs in the center console of a 2000 Oldsmobile Silhouette, first, remove any necessary trim pieces around the console by gently prying them off. Next, locate the bulb sockets and twist them counterclockwise to release. Replace the old bulbs with new ones, ensuring they are the correct type, and reassemble the console by reversing the disassembly steps. Finally, test the lights to ensure they are functioning properly.
Pull the plastic trim that surrounds the radio and center stack, remove the screws that hold it in, pull it out and unplug it. Reverse to install.
For 3.5l, remove starter.