The dash plate just pulls out, if that makes sense. Just be careful not to scratch the dash itself when you take it out. To get to it, you'll have to take the cover off the steering column. This plate (if this is the one that surrounds the gauges, you'll want to pop it loose with something plastic, like a spoon or your fingers.There are two or three screws that hold that on. Make sure the retainers are inside the holes before you snap it back in. Good luck.
First you must remove the dash plate that is held on by clips. So you must pull on it to get it off. Then there is four screws in the front and a ground bolt in the back. And you must remove the wire harneses and antena cable.
The factory amp on a 1999 dodge intrepid is located on the right kick panel behind the dash.
It is inside the passenger side of the dash.
Inside the dash, in the HVAC housing. The entire dash has to be removed to access.
Ask a Loacl. HOW do you remove the dash board on a 1996 dodge avenger
A 1994 Intrepid is OBD1. The connector is a 6 way under the dash on the driver side.
The body computer is in the far passenger side of the dash.
it's actually fairly easy. there are screws where the speedometer is and under the dash. remove them and the front part of the dash just drops. now the kit for aftermarket installations is hard to find for a 2001. the kit i used was for a 2000 intrepid. fits perfectly.
Under the dash, inside the ac box, passenger side
It is under the dash, driver side. Attached to the fuse box.
The horn relay on a 2004 Dodge Intrepid can be found in the fuse box under the dash on the driver's side. It is a small, rectangular shaped plug in to the left of the hazard flasher plug in.
No. It has a unlit reference. The illuminated selector in on the center dash.