You break it!
remove the 2 plastic screw knobs directly on top of headlight assembly, they will most likely be rusted in so you might have to use vice grips or channel locks to break them loose, after that the assembly will pull straight up and out.
Remove headlight assembly to access bulb/socket.
To remove the parking light assembly from a Jeep Compass, start by opening the hood and locating the screws or clips securing the assembly. Use a screwdriver or appropriate tool to remove these fasteners. Next, gently pull the assembly out from its housing, being careful not to damage any connected wiring. Once detached, you can replace the bulb or the entire assembly as needed.
Lift the hood and loosen the round screw heads directly above lights - 2 on each. lift assembly off of the rack and unplug light
To replace the back tail light bulb on a 1984 Buick Electra Park Avenue, first, open the trunk and locate the tail light assembly. Remove the retaining screws or clips securing the assembly, then carefully pull it out. Disconnect the wiring harness and twist the old bulb counterclockwise to remove it. Insert the new bulb by twisting it clockwise, reconnect the wiring harness, and reassemble the tail light assembly.
For the rear... Remove the plastic nuts that hold the carpet on(behind the tail lights) and then you can easily remove the bulbs For the Front... You have to remove 2 bolts (that have plastic heads that your can turn with your hand) and remove the entire headlight assembly on that side
How to remove headlight assembly on 2003 Lexus GX470
remove the ashtray from the assembly you will then find a screw that needs removed . remove that and the assembly will come right out
How do you remove the headlight assembly on a 2001 camaro?"
I would like to know how to remove the radio in a 1986 chrsyler 5th avenue
Remove the tire and wheel. Remove the brake assembly and rotor. Remove the axle end cap. The rear hub assembly will come off.
On a 1995 GMC Jimmy with a Vortec engine, the fuel injectors are located within the intake manifold, specifically under the upper intake manifold assembly. To access them, you typically need to remove the air intake assembly and the upper intake manifold. The injectors are mounted directly to the lower intake manifold and are connected to the fuel rail, which supplies them with fuel.