its not verry dificult. #1 remove the Phillips screws theirs one in the door handle,the lower left corner of the panel ,upper right next to the pillar # 2 their is a cover on the window lever, pop it off and theirs an T type screw inside remove it then the handle . the door pannel should lift up and then off . The speaker itself , remove 4 screws ,un plug and replace the size is 5x7 all around 2 front and 2 rear .
Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.
To replace the back speakers in a 2006 Acura TL, remove the SRS housing on both sides and the back panel of the speakers. Remove all wiring attached to the speakers and replace.
Front speakers are in the door. remove screws on the door panel, then remove the panel and you'll see the speaker
with a hammer
Remove door panel, remove 4 screws, remove speaker, put new speaker in, replace screws, replace door panel. Done.
you have to remove the door panel
In order to replace the speakers you have to flip down the rear seats and look at the screw ports and remove all the screws to remove the panel covering the speakers. The rest is self explanatory.
You have to remove the door panel, after that you will be able to replace the speaker.
Yes the door panel must be removed to gain access to the speakers. Just replace them It will sound better.
power door or manual
link here: http://www.craigcentral.com/durango/speakers.asp
# Remove the door trim panel # Remove the mounting screws withdraw the speaker unplug the electrical connector and remove the speaker