answersLogoWhite

0

What you have is called the lock plate for the steering wheel. Go to your favorite auto parts store and ask them for a lock plate hold down tool. It will be needed to depress the plate's spring, so the snap ring can be removed that is holding the lock plate onto the steering shaft.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Where is the ignition switch located on 1997 Oldsmobile bravada?

The ignition switch is located inside the steering coulum below the key and tumbler.


How do you remove the ignition switch tumbler on a 1986 dodge lancer 2.5?

Remove the screws on the side of the steering column. Remove the screws underneath the steering column and pull the bottom half of the column down. Slide a pin punch into the hole at the ignition tumbler assembly's bottom. Force the tumbler upwards and pull it out of the steering column.


How do you replace key and tumbler 1986 Cadillac Fleetwood?

To replace the key and tumbler in a 1986 Cadillac Fleetwood, first, remove the steering column cover by unscrewing it. Next, insert the original key and turn it to the "Run" position, allowing you to access the tumbler release pin. Use a small tool to press the pin while pulling out the old tumbler. Finally, insert the new tumbler, ensuring it aligns properly, and reassemble the steering column cover.


Do you have to take the steering wheel off to change a ignition lock tumbler on a 96 Chevy Tahoe?

yes


How do you change key and tumbler in 2001 gmc jimmy?

To change the key and tumbler in a 2001 GMC Jimmy, first, ensure the ignition is in the OFF position and disconnect the battery. Remove the steering column covers to access the ignition switch. Use a small tool to press the pin on the switch and turn the key to the "Run" position to release the tumbler. Once removed, install the new tumbler by aligning it and locking it in place before reassembling the steering column and reconnecting the battery.


Hiw do you replace ignition tumbler on 1993 chey cheyenne?

To replace the ignition tumbler on a 1993 Chevy Cheyenne, first disconnect the negative battery cable to ensure safety. Remove the steering column cover by unscrewing the screws and gently prying it apart. Insert the key and turn it to the "run" position, then locate the release pin on the ignition switch; push it in while pulling the tumbler out. Finally, insert the new tumbler, ensuring it clicks into place, and reassemble the steering column cover.


How to change a key tumbler on a 1998 cadillac northstar?

When you say key tumbler, are you referring to thr ign key cylinder, door , glove box or trunk cylinder. All tricky, most difficult--steering col lock cylinder. Steering wheel, signal switch, must come off.


How do you change the ignition switch in a 1990 Pontiac Grand Prix without pulling the steering column?

the ign switch or the key & tumbler ???


How do you replace ignition switch on 97 gmc jimmy?

Pull your steering colum apart along with steering wheel and dash plastic, ignition swith is next to the key tumbler. Swap the parts.


How do you change the key tumbler on 2000 Saturn?

To change the key tumbler on a 2000 Saturn, first, remove the ignition cylinder by disconnecting the battery and taking out the steering column covers. Then, insert the key and turn it to the "Run" position while pressing the release pin on the ignition cylinder. Once removed, you can replace the old tumbler with a new one, ensuring it aligns correctly with the new key. Finally, reassemble the ignition cylinder and steering column covers, and reconnect the battery.


How do you remove key lock switch-from 2003 Buick century steering column?

On the GM cars I've worked on, you have to remove the steering wheel. There is a vertical retaining bold/pin that has to be remove to allow the tumbler/key lock cylindar. Remove the wheel. Remove the retaining pin. Then remove the tumbler. Reverse the above to install the new one. Hope that helps.


What is the name of the ignition component in steering column of 1994 buick regal but not the key ignition switch?

The ignition switch. Where the key goes in is the key tumbler.