== == == == you don't it's molded int to the bumper.
A person can remove the front license plate cover on a 1990 Corvette with a screwdriver. The plate can then be replaced with a custom plate or a state plate if required.
On the drivers side in front of the cross member. You have to remove the black plastic cover to get to it. It faces the front of the car.
There are screws holding it on. Un-screw them.
Lay down on the ground in front of the cover,look between the cover and the bumper and you'll see two Phillips head screws.remove them and your cover will be off.I just did this.
To remove the front license plate cover on a Firebird, first locate the screws or fasteners securing the cover, which are usually found at the top or bottom. Use a screwdriver or socket wrench to unscrew them. Once the screws are removed, gently pull the cover away from the bumper to detach it. If the cover is clipped in, carefully pry it off using a trim removal tool to avoid damaging the surrounding area.
Remove bottom of the license plate cover by slowly pulling outwards. It is glued with a HEAVY 3m tape. The top of the cover is different it has 3 hidden tabs across the top. Slide a flathead screwdriver down from the top of the cover and slowly work each tab out of its slot. There is on the upper left and right and one in the middle.
It depends on the state you live in. Some states require vehicles to have front license plates at all times, while others do not. Check your state's laws to see if it is legal to remove your front license plate.
you have to pull the front motor mount off the core support, then voila, easy as pie from there
There are two screws on the bottom of the cover. You should have just enough room to fit a screwdriver in between the nose of the car and the cover without scratching the paint. It might be tight, but the cover should give enough for you to get tools in there.
Are there people that use the front license plate still? lol Well taking them off if you are using them is quite easy, get a screwdriver and take the bolts out. Now if you have a custom plate holder you can get a detailed answer by visiting smokinvette.com. Good luck!
pull front of rear seat up. remove it and battery is right there
In the back of the seat (both) you have a star screw bit that one you remove it you lift up on the back of the seat and the front will come up out of a groove that it slides into.