To remove the glove box from an S10 pickup, first, open the glove box and remove any contents. Next, locate the screws or bolts securing the glove box hinge and the stops; these are typically found on the sides and bottom of the glove box. Remove these fasteners using a screwdriver or socket wrench, then gently pull the glove box out of its mounting brackets. Be cautious of any wiring or clips attached to the glove box and disconnect them if necessary.
Inside the dashboard, to the right of the glove box.
Behind the glove box
The heater core comes out from the inside. If you have air it is a little harder. Remove the dash bolts it does not need to come all the way out. also remove the glove box this will help you remove the heater box which the heater core is behind pretty easy after the dash is out of the way hope this helps
The flasher relays are in the back of the glove box the fuses are on the left side of the dash and can only be accessed if the driver's door is open
in a compartment in the glove box.
In the back of the glove box good luck check the fuses first the fuse box is on the left side of the dash you can see it only when the driver side door is open.
I need a diagram of the fuse box panel in a 1985 Chevy s10 pickup. Thank you.
In the back of the glove compartment you will see a door marked relays. It's in there.
Need to know what year you have.
The ECM on a 1992 S10 Blazer is located below the glove box.
Should find it in the passengers side kick panel or behind the glove compartment.
The fuel pump relay on a 1995 Chevrolet S10 pickup is located underneath the hood. The fuel relay will be inside the fuse box.