To remove the headlight assembly you need to remove the front bumper cover. There are two bolts and one stud with a nut that hold the headlight in. Two of the fasteners are behind the bumper cover. Took me about two and a half hours. Make sure the problem is the bulbs. When it happened to me the bulbs were ok. The real problem was the relay was not grounded. The ground is what the switch controls.
You must remove the front bumper to access the headlight.
First remove the headlight assembly by removing the grill. Remove the bulb. It can be tricky to remove the grill if you are not careful. Remove the clips that hold in place. Install the new headlight.
You have to remove the front bumper, remove the headlight assembly. then take the fog light bulb out.
how do you remove the starter fro cadillac cts 2005
You remove a few bolts to remove the entire headlight assembly. There is a video on YouTube on exactly this. Do a search for Forenza Replace.
you have to remove the two screws on top of the headlight assembly then you have to reach under the headlight between the headlight and the bumper and pull it out.i'd use a piece of cloth to cover the chrome on the bumper this vaw you don't scratch it.once you pull out the assembly then unplug it and change the bulbs you want..
Open the hood and then examine the top of the headlight assembly and locate the two pins that can be pulled up and out of the assembly. Then rotate the headlight Assembly out of the front of the grille and change the headlight bulb...reverse the process
there are two screws holding the light assembly to the car. Remove the two and replace after removing headlight
You will need to take the complete headlight assembly loose or out to get to the bulb to change it.
To replace the headlight on a 2005 Ford 500, first, open the hood and locate the headlight assembly. Disconnect the electrical connector by pressing the tab and pulling it out. Remove the headlight bulb by turning it counterclockwise and replacing it with a new bulb, making sure not to touch the glass with your fingers. Finally, reconnect the electrical connector and test the new headlight to ensure it works properly.
It will vary depending on if you have the HID lighting system option or the Halogen lighting system option. See Sources & Related Links below for headlight bulb information.
This just isn't something that you want to do. Remove engine shroud, grill, bumper on the side that you're working on, inner fender fasteners - then you can get to the 4 bolts that hold the headlight assembly in. Did it yesterday - won't do it again. 5 hours :-(