Remove instrument cluster in a 2003 olds aurora
To get a 2003 F-150 Truck to start after replacing the instrument cluster the cluster will have to be re-programmed. A dealer or possibly a locksmith can reprogram an instrument cluster.
You take the screws out of the dash and remove the dash. Be careful or you will break it. After you get it off, you will have to disconnect like 3 wires to get it off, there are screws on the instrument cluster. You remove those and it pops right out. Mine went out in my trailblazer.
Removal and Installation Remove the instrument cluster finish panel. Remove the lower steering column cover. Remove the lower steering column cover retaining bolts. Position the parking brake release aside and remove the lower steering column cover. Remove the retaining bolts and remove the lower steering column reinforcement. Position the transmission range indicator cable out of the way. Disconnect the cable.Remove the retaining screw and position the cable aside. Remove the instrument cluster screws and position the instrument cluster aside. Disconnect the electrical connecters and remove the instrument cluster. To install, reverse the removal procedure.
in front of the instrument cluster the black "hood" piece remove it and have fun
1. remove the entire dash board 2. remove the instrument cluster 3. change bulb
The fuse for the instrument cluster in a 2003 Chevrolet Avalanche is typically located in the fuse box under the driver's side dashboard. Refer to the owner's manual for the specific fuse box location and the fuse diagram to identify the correct fuse for the instrument cluster.
You'll need to remove the instrument cluster. First, remove the radio/climate control panel and the lower dash panel. Then you need to pry out the headlight switch, undo some screws that hold the upper dash trim panel, and remove it. This will give access to the four screws that hold the cluster in. Carefully reach behind and undo the two plugs into the rear of the cluster. Remove the cluster and put it down carefully on a clean towel. The bulbs are mounted in twist-to-remove sockets which you can only access from the back of the cluster.
hy i got the same problem mow i need a instrument cluster dont know wher to get one
To remove the gauge cluster on a 2003 Acura RSX, first, disconnect the negative battery terminal to ensure safety. Next, pry off the plastic trim surrounding the cluster, then remove the screws securing the gauge cluster in place. Carefully pull the cluster out, disconnect the wiring harnesses at the back, and you can then fully remove the cluster. Reinstalling is simply the reverse process.
Yes
Should be on a panel under the dash undernieth the instrument cluster.
you need a new cluster, from the dealer, usually about $250- 300