* Remove the mirror trim cover from the door panel * Remove the three mirror retaining nuts and detach the mirror from the car
To replace the passenger side mirror on a 2006 Jeep Commander, start by carefully removing the interior door panel to access the mirror's wiring and mounting screws. Disconnect the electrical connectors and unbolt the old mirror from the door. Install the new mirror by securing it with the bolts and reconnecting the electrical wiring. Finally, reattach the door panel and ensure everything is properly aligned and functioning.
The mirror cover can be removed by removing the mirror cover retaining bolts. You can access the retaining bolts by removing the inside door panel.
Mirror Mirror - 2006 was released on: UK: 12 August 2006 USA: 13 April 2006 (New York City, New York)
* Remove the mirror trim cover from the door panel * You will see three retaining nuts check/tighten them
first remove the screws in the door panel then remove inside door handle 10mm screw on the inside edge of handle.gently lift up on the door panel.now you have acess to the electrical connector and the three nuts that hold on the mirror
To remove the headlight assembly on a 2006 Jeep Commander, first, open the hood and locate the headlight assembly. Remove the screws or clips securing the assembly, typically found at the top and possibly on the sides. Disconnect the electrical connector by pressing the tab and pulling it out, then carefully pull the headlight assembly out of the housing. Repeat for the other side if necessary.
All you have to do is remove the black cover on the inside corner be careful as it is clipped and it is easy to break..The nuts holding the mirror are 8mm just remove them..Disconnect the wire connector and it pops right out...
Jeep Commander was created in 2006.
Field Commander happened in 2006.
You may be able to go to a glass store and have it replaced reasonably
The Boxing Mirror was created in 2006.