0
What else can I help you with?
Where is the camshaft sensor on a Malibu LS 2000?
camshaft sensor is under power steering pump. remove steering pump, then set aside do not remove hoses. sensor is down, remove one bolt that holds sensor in, then pull up on sensor to remove.
How do you remove power steering pump on 2002 Chevy Malibu?
To remove the power steering pump on a 2002 Chevy Malibu, first ensure the engine is off and the keys are removed. Disconnect the negative battery cable, then remove the serpentine belt by loosening the tensioner. After draining the power steering fluid, disconnect the pump's hoses and wiring harness. Finally, unbolt the pump from its mounting bracket and carefully lift it out.
Where is the cam position on a 3100 engine on a 2000 Malibu?
the cam sensor is under power steering pump! remove pump then set aside,do not remove any power steering hoses, cam sensor is reachable now!! take out bolt that holds it in place,pull straight up to remove..
How do you replace the cam sensor gasket on a 2000 Malibu?
on the 3.1, it is under power steering pump. remove pump but not the hoses, set aside. sensor only has 1 bolt to hold it in. remove bolt then pull it straight up and out.
How much is it to replace camshaft position sensor on a 2000 Chevy Malibu?
if you do it yourself,you only pay for sensor!! to change sensor on a v6, remove power steering pump and set aside do not remove hoses,sensor is under pump!! remove hold down bolt then wiggle it out!!
How to replace the power steering pump silhouette?
Remove the belt by loosening the tensioner pulley. Remove the power steering hoses. Remove the retaining nuts. Reverse the process to install the new power steering pump.
How do you replace a power steering pump on a 1969 Chevy 327 engine?
Remove the belt from your 1969 Chevy power steering pump. Remove the power steering pump hoses. Remove the power steering pump retaining bolts. Reverse the process to install your new power steering pump.
How do you replace the power steering pump on a 1983 Chevrolet truck?
Disconnect hoses at pump. When hoses are disconnected, secure ends in raised position to prevent drainage of oil. Cap or tape the ends of the hoses to prevent entrance of dirt. Install two caps at pump fittings to prevent drainage of oil from pump. Loosen bracket-to-pump mounting nuts. Remove the pump drive belt. Remove pump from attaching parts and remove pump from vehicle.
1997 Nissan altima power steering pump replacement?
Begin by removing the power steering pump belt. Remove the power steering pump hoses. Remove the power steering pump retaining bolts. Reverse the process to install your new power steering pump.
How do you replace the AC compressor on a 1997 Chevy Malibu?
Remove the air conditioning hoses from your 1997 Chevy Malibu air conditioning compressor. Remove the compressor belt. Remove the compressor retaining bolts. Reverse the process to install your new air conditioning compressor.
How do you remove power steering pump on 1993 Buick park avenue?
To remove the power steering pump on a 1993 Buick Park Avenue, first, disconnect the negative battery cable. Then, drain the power steering fluid and remove any brackets or hoses attached to the pump. Unbolt the pump from its mounting location and carefully take it out. Finally, replace it with the new pump, reattach hoses, and refill the power steering fluid.
How do you remove power steering pump from a 91 olds ceria 4-cylinder?
The power steering pump is held on by several bolts and hoses and the power steering belt. Loosen one of the bolts on the pump to adjust it down so you can remove the tension from the belt. Once that is done, start removing the hoses carefully. They will be leaking fluid so it's good to place a rag underneath. Once the hoses are disconnected, remove the bolts holding the pump in place and it will be free.
