0
First you must remove the cross support. This is across the front/top of radiator and is in your way. It is only four bolts. They all face up. Two on left, two on right.
Secondly remove the two coolant hoses ( top left/bottom right) and the two transmission lines (right side top and bottom).
Third remove the two bolts holding the radiator in (top left and right). These all face towards the front of the car. Now you can move the radiator, electric fans and a/c condensor around some.
Fourth remove the four bolts that hold the a/c condensor to the radiator ( two on the right top/bottom, two on the left top/bottom). These four bolts face towards the front of the car. The top two you can get from above, the bottom two you will have to get at through the front of the bumper.
Fifth remove the electric fans. Four bolts facing the engine. Top/ bottom left/right.
You can now remove the radiator. Before putting the new one in remove and replace all of the bolt clips. There will be 10. Also replace the bushings at the top radiator bolts and the bottom and make sure that the old ones are goen or the radiator won't fit. That is it.
When you remove the radiator from the car there are 4 bolts that you have to go trough the bumper to get to because they are connected to the air conditioning condenser. there is then two bolts to the frame at the top. and you have to remove the crossmember that has the hood latch on it to pull it out. that's how I got mine out (hope it's the same).
What else can I help you with?
Where is the radiator petcock located on a 1994 Dodge Intrepid?
On the lower right of the rad. Sometimes it is easier to remove the lower rad hose.
How do you adjust the bands on a 1994 Dodge Intrepid?
The transmission in an Intrepid does not have any bands in it.
Does a 1994 Dodge Intrepid have 2 thermostats 3.5 v6 motor?
No, just one under the housing where the upper radiator hose hooks to the engine.
Does the motor remove from the top or the bottom on a 1994 Dodge Intrepid?
Depends on if you have a lift or not. You can take it out from the top, or if you have a lift, remove the engine cradle and lower it down.
What is the refrigerant in a 1994 Dodge Intrepid?
R-134a
Is a 1994 Dodge Intrepid fuel injected?
Yes
Can a 2002 starter fit 1994 Dodge Intrepid?
No
Where is the O2 sensor on a 1994 Dodge Intrepid?
The 1994 Dodge Intrepid O2 sensor is located on the outside of the air cleaner housing. The sensor is on the back side of the housing.
Where is the obd 2 plug on a 1994 Dodge Intrepid?
A 1994 Intrepid is OBD1. The connector is a 6 way under the dash on the driver side.
How do you replace thermostat on 94 Dodge Intrepid?
To replace the thermostat on a 1994 Dodge Intrepid, first ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing, take out the old thermostat, and clean the mating surfaces before installing the new thermostat with the spring side facing down. Reassemble the housing, reconnect the hose, refill the coolant, and check for leaks.
Will a 1994 3.3 v6 Dodge engine go in a 2002 Intrepid?
No
Where is the inertia switch on a 1994 Intrepid?
Dodge does not use inertia switches.
