The rear panel can be removed by first taking out the blank panel at the bottom of the panel arm rest. It's a small about 3" long panel and it just clips out. This exposes two torx screws that hold the arm rest to the door. Remove those. There may be a screw behind the door latch also, but I don't remember. Anyway, those are the hidden screws. Once they are removed, the whole panel can be pulled off, it is attached with those slip in GM plastic fasteners. If you break them, don't worry, they are available at AutoZone, or about any other parts place. The panel will unclip and then go up to clear the upper clips by the window. The power window and lock buttons can also be disconnected by unclipping them from the panel, and removing the wires after opening the clip holding them on to the switch.
What is the firing order on a 1988 Buick Century.
what is the order of push rods for buick century custom 3.1 engine
The 1989 Buick Century oil sender is located inside of the oil pan. You will need to remove the oil pan in order to view the oil sender.
Behind the power steering pump on the passenger side.The pump will have to be removed in order to remove the blower motor.
12345678
1,4,2,3
246135
The firing order for a 2002 Buick Century 2002 is 1, 2, 3, 4, 5, 6. Cylinder number one is at the front left.
The firing order for a 4 cylinder 1994 Buick Century is 1, 3, 4, 2. For the 6 cylinder engine the order is 1, 2, 3, 4, 5, 6.
Yes
Fuel pump is located inside the gas tank, you need to remove the fuel tank from the car in order to have access to the fuel pump.
1,2,3,4,5,6,7