There are 2 bolts at the front and bottom of the rear seat just where the rear floor board begins to go under the seat. One is behind the driver seat the other behind the other behind the passenger seat. If I remember correctly you just remove those two bolts and it should slide out.
May have to remove rear seats and get in from there
what is the ratio of gears in a 1986 cutlass
The rear license plate bulbs on a 1996 Olds Cutlass Supreme are replaced by removing the retaining screws, pulling the light assembly out, and disconnecting the wiring harness. The bulb can then be twisted to remove it and a new bulb put in place.
The 1987 Oldsmobile Cutlass Supreme was rated 350 horsepower with the with the V8 engine. It was last year that the Cutlass was a rear wheel drive vehicle.
4x10
Remove seats
Front = 3 & half, Rear = 4x10
Yes
Equalizer valve not allowing fluid flow to rear?
Chainsaw
The low side service port to recharge the AC on a 1997 Olds Cutlass Supreme is at the rear of the engine. It is close to the firewall.
four. Two 4" speakers in the dash, and two 6x9's in the rear. The ones in the dash are really difficult to get to. You have to remove the whole dash. (: