0
its actually pretty simple,pull the ash tray out at the bottom of the center console,there will be a screw at both bottom corners near ash tray.remove these screws and gently pull out on the bottom of the cover that surrounds the radio and the heater controls until it comes free. once you pull the cover off then you will be able to see the four screws that hold the radio in place,remove them and pull radio out.
What else can I help you with?
Where is the daytime running light control module in a 2000 Pontiac Montana?
Have you tried looking behind the center vents above the stereo?
How do you remove stereo from 2000 Nissan Pathfinder?
How do you remove stereo from 2000 nissan pathfinder?
Cylinder Torque sequence 2000 Pontiac Montana SV6?
What is the Cylinder Torque sequence 2000 Pontiac Montana 3.4V6
Where is vacuum modulator on a 2000 Pontiac Montana?
The 2000 Pontiac Montana does not have a vacuum modulator installed on it. Instead, it has an electronically controlled transaxle.
How do you change freeze plugs in Pontiac Montana?
where is the freeze plug located in a 2000 pontiac montana mini van
How do you remove the stereo dash panel on a 2002 Pontiac Grand Prix?
Ihave 2000 grand prix how to remove dash board to remove radio Go to http://www.carstereohelp.com/stereoremovalPontiacGrandPrixSt2.htm
Where is the blwrmtrresistor located on a 2000 Pontiac Montana?
above passenger feet. remove cover, reach as far forward as you can, you will see the connectors.
Refrigerant type in 2000 Pontiac Montana?
r134a
How do you recharge the air conditioner in a 2000 Pontiac Montana?
No
How long does a fuel pump for a 2000 Pontiac Montana last?
my 2000 Montana is still on its original fuel pump
Where are the oxygen sensors located in the 2000 Pontiac Montana?
they are located in the exhaust system Where ? how many 02 sensors on a 2003 Pontiac Montana
How do you remove the wiper switch on 2000 Pontiac Montana?
To remove the wiper switch on a 2000 Pontiac Montana, first disconnect the negative battery cable to ensure safety. Then, remove the steering column cover by unscrewing any screws and gently prying it apart. Disconnect the electrical connector from the wiper switch and remove any screws securing the switch to the column. Finally, pull the wiper switch out and replace it as needed.
