What sequence is used to remove radio from 2004 sububan
To remove the door panel on a 1988 suburban, first remove any light lenses and stereo speaker covers in the door. Then, gently pull at the corners with a screw driver to remove the larger panel.Ê
remove the aircon vent panels next to the system
The real answer: Remove the stereo from the dash board and disassemble it to release the disk. I had a new stereo so I used a hammer and a big screw driver the last time I had to do this.
Here is a step by step tutorial for a 2004 Forester.Just copy the link below.http://www.computerizedmachining.com/remove-stereo-2004-Subaru-Forester.htmlThat site will help anyone remove the factory stereo from a 2004 Subaru Forester. This site has Photos and written instructions to make sure you can get the job done right. This site also has NO ADs, No Registration required.
put the parking brake in, then put the truck in 1st gear pop the dash cover off and then remove bolts from stereo.
BEHIND the starter. You MUST remove the starter to get to it.
Follow the link below. Its a step by step on how to do this.
The answer is the same as for a 2004 Tacoma. See the response here:How_do_you_remove_the_factory_radio_on_a_2004_Toyota_Tacoma
There isn't one. You have to remove the lower radiator hose, which is a poor design.
Remove the decorative stereo cover. Remove the stereo retaining screws. Pull the stereo out. Remove the wiring harness and the antenna cable.
Remove the retaining cover from your stereo. Remove the stereo retaining bolts. Slide the stereo out and remove the wiring harness. Reverse the process to install your new stereo.
Remove the decorative stereo cover. Remove the stereo retaining screws. Pull the stereo out and remove the wiring harness and the antenna cable.