0
What else can I help you with?
How do you remove and install new quarter panel tail lights on a 1999 Lexus gs400?
Access the trunk, lights are held on by bolts and connected by a wire harness behind the carpet.
How do you install a wiring harness for a trailer hitch on a 2003 Jeep Cherokee?
you have to remove the back driver trim in the back of the jeep..........you will find a green plug, the aftermarket wiring will plug into that.......................good luck
How can I rewire a trailer?
To rewire a trailer, first disconnect the old wiring and remove it. Then, install new wiring following the color-coded diagram for proper connections. Secure the wiring in place and test the lights and brakes to ensure they are functioning correctly.
How do you change fog lights on 2004 dodge SX 2.0?
Remove the fog light retaining bolt. Remove the fog light wiring harness. The fog light will come out. Reverse the process to install the new fog light.
Honda pilot left turn arrow does not blink when you apply brakes?
If you have a trailer wiring harness it probably has a short in it and is back feeding the circuit when the brakes are applied remove and replace the trailer harness and this should fix the problem.
How do you install trailer harness in 2004 Honda Odyssey?
Visit auto parts store and order Hoppy 43105 harness. Remove interiorrear panel just above bumper and interior driver side rear quarter panel (where the jack storage is). You will find an unused wiring harness that is taped out of the way. Use this to connect it to the harness and route the wiring into the jack storage area.
Where do you plug in wiring harness for trailer lights in my 2008 Gmc Sierra?
I think the plug is behind the passenger side tail light remove the plastic pin and pull back the mud guard. You may need to remove the tail light too depending on the kit you bought
How do you fix the hazard light switch on a 97 Crown Victoria?
Remove the wiring harness from the back of your 1997 Ford Crown Victoria hazard lights switch. Remove the hazard light switch retaining screws. Reverse the process to install your new hazard light switch.
How do you remove the tail lights on a 2004 Toyota Camry SE?
from inside trunk remove trunk liner to expose back side of lights locate screws and remove install is the reverse
How do i replace a sonata power window switch?
Remove the door panel. Remove the switch retainer. Remove the wiring harness. Reverse the process to install the new switch.
How do you repair a clock?
Remove the clock decorative cover. Remove the clock retaining ring. Remove the clock wiring harness. Reverse the process to install the new clock.
How do you replace the alternator on a 2001 Chevy Corvette?
Remove the accessory drive belt. Disconnect the negative battery cable. Disconnect the generator electrical connector. Remove the engine harness terminal from the generator: - Slide the boot back along the cable. - Remove the engine harness cable nut (3). - Remove the engine harness terminal from the stud. Remove the generator bolts and generator. Install the generator. Install the generator bolts. Tighten the generator bolts to 50 N
