0
this all depends on how the valves sit inside the head cylinder, you have two different types of valves which is, 1} insinked valves 2} standard valves. to determine the differences between the two, the insinked valves are valves that have been sinked inside and into the engine head cylinder, the steps down below follow for non insinked valves inside the head cylinder. for normal valves you can buy a tool from a spare part shop to take the standard valves out but if you have insinked you need a machine to take them out but if you go like i did to a head specialist they could do it for you and put them back in because the have a hydralic/air compressor that does the job. ok!
1.step= take the rocker cover off. 2.step= take the cam shaft off. (TAKE NOTE PLEASE : the timing belt will have to come of aswell) 3.step= (if over head cam) remove caps from the top of valves. 4.step= remove the head from engine. 5.step= remove the valves with the valve remover tool purchase from any spare part shop. as mentioned before if they are INSINKED you will have to compress them out.
that should answear your question to the finest detail that i can put it for you.
What else can I help you with?
How can check for electric panal in daewoo nubira?
when the car is cold the ingine not run unitil i remove the battery also inicate service daewoo nubira one model 1999
When did production of the Daewoo Nubira cease?
The Daewoo Nubira's first model was the J100 released in 1997 and was sold until 1999. It ended its run in the United States in 2002 with the remaining stock being auctioned off to Dealerships and some taking 3 years to be sold.
What engine is in a Daewoo nubira 2000 model?
2.2L D-tech . Its a 16 valve, dual overhead cam engine, with 130hp.
Where is the fuel filter on a Daewoo nubira 2005 CDX model?
The fuel filter on a 2005 Daewoo Nubira CDX model is typically located along the fuel line, either under the vehicle near the fuel tank or in the engine compartment. To access it, you may need to lift the car and remove some underbody panels or check around the fuel rail in the engine area. Always consult the vehicle's service manual for precise location and replacement instructions.
Where is the knock sensor located on a 2000 Daewoo nubira?
The knock sensor on a 2000 Daewoo Nubira is typically located on the engine block, near the cylinder head. It is usually mounted on the underside or side of the engine to detect vibrations from the cylinders. To access it, you may need to remove some components for better visibility and reach. Always refer to a service manual for specific details related to your vehicle model.
Where is the Air conditioning Thermostat for Daewoo Nubira 1997 Model?
The air conditioning thermostat for the 1997 Daewoo Nubira is typically located within the vehicle's HVAC (heating, ventilation, and air conditioning) system, often near the evaporator core or inside the dashboard. To access it, you may need to remove the dashboard or certain panels, as it is not readily visible. Always consult the vehicle's service manual for specific guidance on locating and replacing the thermostat.
How much oil does a Daewoo nubira take?
The Daewoo Nubira typically requires about 4.5 to 5 quarts (approximately 4.3 to 4.7 liters) of engine oil, depending on the specific engine model and the oil filter change. It's always best to consult the owner's manual for the exact specifications for your particular vehicle. Using the recommended oil type and adhering to the maintenance schedule is crucial for optimal engine performance.
How do you remove drive shafts left right sides in a Daewoo Nubira Model 2000 CDX 2.0 liter manual?
Jack the vehicle up so that you can get under the car and find the drive shaft. Loosen the nuts where the U-joint connects at the rear of the drive shaft. This will allow you to lower the driveshafts sides and do any other maintenance.
What type of fluid does daewoo nubira automatic transmission use?
Actually there are 2 different transmission fluids Dexron II and Dexron III. If your transmission is electronically controlled, use dexron III (your owners manual will tell you all this!), if it is manually controlled, use dexron II. How to determine if your transmission is electronically controlled! If you can't find a transmission dipstick any where in the Nubira engine chamber, then it'll be electronically controlled. From various sources I have found that, to check the fluid level in this case, you need to remove the speedo cable. nubira a/t model zf 4hp 16 use esso fluid.
What engine fits into a Daewoo Nubria's body?
The Daewoo Nubira typically fits with a range of engines, including a 1.6-liter inline-four and a 2.0-liter inline-four engine. These engines are part of the GM Family II engine family, which was used in several models across the General Motors lineup. Depending on the specific model year and market, the Nubira may also have variations that include different power outputs and configurations. Always consult the vehicle's specifications for precise compatibility.
How does the vacuum hoses connect of daewoo nubira 1.6 se?
In the Daewoo Nubira 1.6 SE, vacuum hoses connect various components of the engine and emission systems to manage air intake and ensure proper operation. Typically, these hoses link the intake manifold to devices such as the brake booster, fuel pressure regulator, and vacuum actuators. It's essential to ensure that these hoses are securely connected and free of cracks or leaks to maintain optimal engine performance. For accurate routing, it's advisable to refer to the vehicle’s service manual or a diagram specific to the model.
How do you program the key on a daewoo matiz 2000 model?
You have to take it to a Key reprogrammer, or your local daewoo who will reprogramme it for you.
