0
To remove the crank handle from this and quite a few other vehicles do the following .. 1) Buy a handle removal tool from your local autostore - shaped a bit like a jagged, thin spanner and costs only a few dollars. 2) Insert under the bigger plastic moulding around the shaft of the handle that acts as the trim. You're looking to push out a clip that's like a long C with the top and bottom arms curved in a tad. [Hint: Usually the tool should line up opposite the handle, but not always. Hint2 : When it goes, the clip will spring out so watch it or point down... ]. 3) To reassemble, put the clip into its slots on the handle then just push the handle back on the spline unbtil it clicks in.
What else can I help you with?
How to remove cv axle on 97 Isuzu rodeo?
hoew do you remove a c v axle from a 97 isuzu rodeo front right
How do you replace the shocks on a 1997 Isuzu Rodeo?
How do I remove the front shock bottle pin of my Isuzu rodeo 2000
How do you replace the transmission on a 1999 Isuzu Rodeo?
how do you remove transmission in 1999 rodeo
1997 Isuzu Rodeo V-6 Starter Solenoid Removal what is the Procedure?
How to remove the starter from a 1997 Isuzu Rodeo 4X4 automatic
How do you remove the front tires from Isuzu Rodeo?
remove the six lug nuts
Where do you put the oil in a 1993 Isuzu Rodeo?
The oil in a 1993 Isuzu Rodeo is put into the reservoir that is located on top of the valve cover. There is a cap that has to be rotated to remove it.
Do you have to remove the engine when replacing the head gasket on a 1999 Isuzu rodeo?
no
How do you remove the spark plugs on a 2002 Isuzu rodeo?
Take it to a mechanic!
How do you replace the timing belt tensioner belt on a 1995 Isuzu Rodeo?
Remove beltUnbolt tensioner and remove
When did they stop making the Isuzu Rodeo?
The last Isuzu Rodeo was in 2004.
Steps to remove a strater from a Isuzu rodeo 1998?
locate starter, mark and remove wires, remove bolts, remove starter
How do you remove the rear door panel of a 99 Isuzu rodeo?
To remove the rear door panel of a 1999 Isuzu Rodeo, first, ensure the window is fully closed. Start by removing any screws that are securing the panel, usually found near the door handle and armrest. Next, gently pry off the panel using a trim removal tool, being cautious to avoid breaking any clips. Once loose, disconnect any wiring harnesses for power windows or locks before fully removing the panel.
