0
2000 Ford Ranger Answer There is a thin plastic cover over the window crank handle. It pops out at the large end of the crank (the bottom) and will rotate out of the way so that you can get at the torx screw. The torx screw holds the handle to the shaft. It goes through the center of the shaft. You can use a flat screwdriver to gently pry the cover away from the large end of the crank handle. No special tool is needed. Once you have the handle off remove two other screws, one at the bottom of the door panel and one in the door arm rest. Then grasp the panel at the bottom and slide up to remove. There are no snap pins holding the panel in place. It slides up and off of the door latch for removal.
What else can I help you with?
How to fix rear window leak in 2003 Ranger?
Silicone sealant.
How do you remove the window crank handle on a 2003 ford cargo van?
Should have and Allen wrench slot in center --if not has horseshoe clip behind--tool available at auto parts store
How do I remove the front bumper on a 2003 ford ranger?
Does anyone know how to remove the chrome part of the front bumper on a Ford Ranger XLT
How do you remove rear axle bearing from a 2003 Ford Ranger?
yes
How do you remove a driver side door panel on a 2003 Ford Ranger XLT?
First remove the "cover" on the window crank handle. Pop it off, (it is a press fit and has hooks to hold the cover onto the rim of the center of the crank opposite of the crank arm) swivel it aside to get at the star drive headed screw that holds the handle onto the window crank shaft. After the handle's off remove 2 screws; 1 in the arm rest grab handle and 1 at the bottom farthest from the hinge. After the screws are out the plastic panel needs to be pushed up (there are plastic hooks that engage holes in the inner metal panel) this is tricky but be patient and DON'T use screw drivers or other prying instruments or you'll ruin the plastic panel and it will never fit tight again. Good luck!
How do to remove the window crank handle to get inside the door of a 2003 Chevy S 10 pickup?
there is a C shaped clip behind the handle. I have the tool to remove it you can get them at auto zone. you can also use a small pick to pull clip out but watch out it will fling out
How do you remove the window crank handle from a 2003 Pontiac Sunfire?
It requires a special tool available at the parts store cheap. Use 2 Screwdrivers, force a rag between the door and the window crank handle to give you some space, then pry the clip apart or take a small hook, hook under the loop of the pin and pull up.
How do you remove the window crank on a 2003 Chevy cavalier in order to remove the door panel to fix a rear passenger door that does not open?
You need a door handle removal tool. Go to any auto parts store and buy one. They're about $5
How do you remove a door panel from a 2003 Trailblazer?
With a special tool, remove the door handle and window crank. Take out any screws you can find. With another special tool, remove all of the retainers oon the sides and bottom and raise it up to remove it.The special tools are available from the parts stores cheap.
2003 Dodge Caravan power window motor replacement?
how to replace power window motor for 2003 dodge grand caravan? how to remove side panel dodge caravan 2003?
Where is the crank sensor on a 2003 Z66 with 5.3 engine?
It is behind the starter. You will have to remove the starter to even see it.
Where is the crank sensor on 2003 grand am?
where is crank senser located on 2003 pontiac
