You must remove the A pillar covers first, then gently pry up the panel, it will pop free. there is a couple "velcro" pads that help secure the panel, as well as plastic clips that hold it in place. Be VERY GENTLE with the panel especially when poping it out of the car, as the plastic is very cheap and brittle, thanks to GM bean counters. Be careful handling the panel outside of the car, do not carry the panel flat ( as it is orientated as installed it can be destroyed by its own weight. Be careful if drilling or cutting the panel it is too brittle, you will crack the panel, and it costs 300 $ at ecklers for a new one!
There is a panel in the rear driver side wheel wheel that has one screw and one bolt to remove
If you're replacing the speaker just remove the grill but to take off the door panel remove screws on the handle there are two, remove one screw from behind the door release handle, there is one on the upper side of the door where is latches, there is one on the upper side where the door hinge is then pull up and out because the bottom is slide into place
how to remove the vent from dashboard of 1996 ford contour
The 1996 Ford Escort inside door panel is held in place by eight retaining clips. Pry outward on each retaining clip to remove the door panel.
you take it off, by taking it off how do you remove window hardware from panel?
Removing a door panel on a 1996 Cadillac Eldorado is very simple. The door is held in place by clips and a few screws. Remove the clips and the screws and the door panel comes right off.
The 1996 Mercury Cougar door panel is held in place by eight retaining clips into screws. Remove the screws. Pry outward on each retaining clip.
See link below
they are the exact same
Remove the screws from the handle and then the door panel will slide up. It has clips that will only let it slide up
no they will not
How do I install rear coil springs on a 1996 Camaro?